Loading ...
Loading ...
Loading ...
7
INITIAL INSTALLATION
1.
Remove preassembled motor screws/lock washers
(M) from underside of motor housing (B). If there
are plastic motor blocks installed with the motor
screws/lock washers (M), discard the plastic motor
blocks.
Note: Make sure to keep loose hardware separate
to avoid confusion during installation.
1
M
B
Plastic
Motor
Block
Remove pin (H) and clip (I) from downrod (A).
Partially loosen preassembled set screws and nut
in motor housing yoke at top of motor housing (B).
2a.
2a
H
I
2b
A
Set Screw
Sideview
B
Yoke
2b.
3.
Insert downrod (A) through yoke cover (C). Slip
downrod (A) into motor housing yoke, align holes
and re-install pin (H) and clip (I). Tighten set
screws in motor housing yoke and then tighten
preassembled nut on one of the set screws. Then,
slide yoke cover (C) down until it rests on top of
motor housing (B).
3
B
C
I
H
Yoke
H
I
Set Screw
and Nut
Sideview
A
Loading ...
Loading ...
Loading ...