Craftmade WC42ORB5C3F Wyman 42" LED Oil-Rubbed Bronze Indoor Ceiling Fan

User Manual - Page 5

For WC42ORB5C3F.

PDF File Manual, 18 pages, Read Online | Download pdf file

WC42ORB5C3F photo
Loading ...
Loading ...
Loading ...
page 5
5. Wiring.
Install hanging bracket to outlet box using original
screws, spring washers and flat washers provided
with new or original outlet box.* Pull electrical
wiring from outlet box through center hole in the
hanging bracket.
*Note: It is very important that you use the proper
hardware when installing the hanging bracket as this
will support the fan.
4. Hanging Bracket Installation.
(cont.)
hanging
bracket
spring washers
outlet box screws
flat washers
hanging
bracket
j-hook
motor assembly
*
WHITE
WHITE
BLACK
BLACK
BLUE
GREEN
GREEN
wire
connector
(supply circuit)
WHITE
BLACK
SWITCH
outlet box
GROUND
(GREEN
OR BARE)
WARNING: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
Lift motor assembly to hanging bracket and
slide slot at one end of motor assembly over
j-hook on hanging bracket. This will allow
motor assembly to hang out of the way while
wiring.
Tip: Seek the help of another person to hold
the stepladder in place and to lift the fan up to
you once you are set on the ladder.
CAUTION: Be sure outlet box is properly
grounded and that a ground wire (GREEN or
Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with
electrical wiring or if the house/building wires are
different colors than those referred to below,
please use a qualified electrician.
When fan is secured in place on the hanging
bracket, electrical wiring can be made as
follows:
Connect BLACK and BLUE wires from fan to
BLACK wire from ceiling with wire connector
provided.
Connect WHITE wire from fan to WHITE wire
from ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together
from fan to BARE/GREEN wire from ceiling
with wire connector provided.
If you intend to control the fan light with a
separate light switch, connect BLUE wire from
fan to the BLACK (or RED) supply from the
independent switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Loading ...
Loading ...
Loading ...