Loading ...
Loading ...
Loading ...
5
ASSEMBLY INSTRUCTIONS
1
4
Motor Screw
Motor Block
3
4. CLOSEMOUNT INSTALLATION (OPTIONAL)
a. Remove the canopy cover from the bottom of the
canopy.
b. Remove the three Phillips-head closemount screws from
the top of the motor assembly.
c. Align the holes in the bottom of the canopy with the
screw holes in the top of the motor housing. The larger
holes in the canopy will encompass the three pre-installed
screws.
d. Secure the canopy to the top of the motor housing with
the closemount screws.
e. Hang the fan on the hook of the mounting bracket.
Proceed to Step 9.
2
Mounting
Bracket Screw
Canopy
Mounting
Bracket
3. Remove the ten motor screws from the underside of
the motor assembly. Discard the motor blocks but keep
the motor screws for blade arm installation.
Note: The notch in the tter plate allows a Phillips
screwdriver access to the motor screws.
If you wish to use the Downrod Mount (as shown on
page 3), proceed to Step 5.
Closemount
Screw
Hook
Canopy
Mounting
Bracket
2. Loosen all four mounting bracket screws, then
completely remove the two mounting bracket screws
from the round holes of canopy. Set screws aside for later
use.
WARNING: To reduce the risk of re, electric shock,
or personal injury, mount to the outlet box marked
“acceptable for fan support” and use the mounting
screws and washers provided with the outlet box.
1.Turn OFF the electrical power at the main fuse or circuit
breaker.
DANGER: Failure to disconnect the power supply prior to
installation may result in serious injury or death.
Loading ...
Loading ...
Loading ...