Loading ...
Loading ...
Loading ...
ENGINETECHNICALiNFORMATiON
This is a single cylinder, L-head, air cooled Model 100000
engine. The Emission Control System for this pressure
washer is warranted for standards set by the Environmental
Protection Agency and the California Air Resources Board.
Certification does not grant the purchaser, owner or operator
of this engine any additional warranties with respect to the
performance or operational life of this engine. The engine is
warranted solely according to the product and emissions
warranties stated elsewherein this manuak
Power Ratings
The gross power rating for individual gas engine models is
labeled in accordancewith SAE (Society of Automotive
Engineers) code J1940 (Small Engine Power & Torque
Rating Procedure), and rating performance has been
obtained and corrected in accordancewith SAEJ1995
(Revision 2002°05). Torque values are derived at 3060 RPM;
horsepower values are derived at 3600 RPM. The gross
power curves can beviewed at
www.BRIGGSandSTRATTON.COM.Net power values are
taken with exhaust and air cleaner installed whereas gross
power values are collected without these attachments. Actual
gross engine power will be higher than net engine power and
is affected by, among other things, ambient operating
conditions and engine-to-engine variability. Given the wide
array of products on which engines are placed,the gas
engine may not developthe rated gross power when used in
a given piece of power equipment. This difference is due to a
variety of factors including, but not limited to. the variety of
engine components (air cleaner, exhaust, charging, cooling,
carburetor, fuel pump, etc.), application imitations, ambient
operating conditions (temperature, humidity, altitude}, and
engine-to-engine variability. Dueto manufacturing and
capacity limitations, Briggs & Stratton may substitute an
engine of higher rated power for this Series engine.
PRODUCTSPECiFiCATiONS
Pressure Washer Specifications
Outlet Pressure .......................... 2,200 PSi*
Flow Rate................................. 1.8 GPM
Detergent Mix ........................ Use as directed
Water Supply Temperature .......... Not to exceed 100%
Engine Specifications
Bore ............................. 2.562 in. (65.08mm)
Stroke ............................ 1.875 in. (47.65mm)
Displacement ......................... 9.67 in. (158cc)
SparkPlug
Type: ............... Briggs & Stratton 802592 or 5095
SetGapTo: ...................... O.030inch(0.76mm)
ArmatureAir Gap: ........... 0.006-0.010in.(O.15-O25mm)
Valveclearancewith valvesprings installedand piston 1/'4in.
(6 mm) past top deadcenter(checkwhen engine is cold).
Intake .................... 0.005-0.007in.(0.13-0.18mm)
Exhaust .................. 0.007-0.009in.(0.18-0.23mm)
FuelCapacity............................... 1.0 Quarts
OilCapacity...................... 18 Ounces(0.53 liter)
NOTICE For practical operation, the engine load should not
exceed85% of rated power. Engine power will decrease
3-1/2% for each 1,000 feet _300 meters) above sea level and
1% for each 10° F (5.6° C) above 77° F (25° C). it should
operate satisfactorily at an angle up to 15°,
This pressure washer is rated in accordanceto the
PressureWasher Manufacturers Association (PWMA)
standard PW101-2010 _Testingand Rating Performance of
PressureWashersl.
15
Loading ...
Loading ...
Loading ...