Loading ...
Loading ...
Loading ...
46
20306742
KHLDV Series Gas Fireplace FINAL INSTALLATION
BRICK, LIGHT BULB, AND LENS PLACE-
MENT— 400/500 SERIES
1. Remove the trapezoidal light shroud located at the back
of the fi rebox by unfastening the three screws.
2. Disassemble the trapezoidal light shroud by unfastening
the four screws which secure the front to the back. Set
lens with the orange painted surface toward the bottom.
Center the lens right to left. Reassemble the front to the
back and set the side.
3. Place the right side panel by sliding it at an angle to clear
the grate. Set the panel straight up and bring forward
until it comes in contact with the reverse bend located
at the front of the fi rebox. Use one of the brackets and
screws provided to secure the panel in place.
4. Place the rear lower panel by setting it over the channel
behind the light socket. Make sure the grout line aligns
with the one on the side.
5. NOTE: Have the left panel bracket and screw handy
before installing the rear upper panel in place. Place
the rear upper panel in place by resting it over the rear
lower panel and sliding it behind the right side panel.
While holding the rear upper panel in place, slide the
left panel at an angle to clear the grate. Set the left side
panel straight up and release the rear upper panel.
Secure the left side panel in place using the second
bracket and screw provided in the kit.
6. Place the front hearth brick simultaneously and pull
toward the front away from the burner. This is critical
for balancing air fl ow around the front burner.
7. Install the halogen light bulb provided with the unit
(inside the log set). Do not touch light bulb directly with
fi ngers.
8. Replace the trapezoidal light shroud removed in step #1
by sliding it over the light bulb and sockets. Be careful
not to damage the light bulb. Align the holes on the
defl ector with the hole on the rear channel and secure
in place.
Figure 58 -
Light Wiring Diagram for Millivolt Unit - 400/500 Series
Junction Box
Light
Light
Light
Rheostat
Blue
Black
White
Black
White
Black
White
Connectors
Blue
FP2154
BRICK, LIGHT BULB, AND LENS PLACE-
MENT— 600 SERIES
1. Remove safety barrier (if installed) by lifting up and out,
then remove glass frame from fi replace.
2. Remove the six (6) screws securing each light box and
remove from unit. Figure 59
3. The light bulbs are included in the log packaging. install
the light bulbs into bulb sockets as shown in Figure 59.
CAUTION: Fingerprints or the transfer of oil from hands
will reduce the lifespan of the bulbs. It is advisable to
handle the light bulbs with a clean cloth.
4. The light lenses are included in the log packaging.
Remove the lens retainer brackets and install the light
lenses into the light box covers as shown in Figure 60.
Bulb Socket
Light Bulb
Light Box
Cover
FP2767
Figure 59 -
Remove Light Box Cover
Lens
Lens Retainer
Bracket
Light Box Cover
FP2768
Figure 60 -
Remove Lens Retainer Bracket
Loading ...
Loading ...
Loading ...