Loading ...
Loading ...
Loading ...
_LCAUTION: Before performing any
service and adjustments:
• Release control bar and stop engine.
• Make sure the blade and all moving
parts have completely stopped.
• Disconnect spark plug wire from spark
plug and place where it cannot come
in contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUNING HEIGHT" in the
Operation seclJon of this manual.
REAR DEFLECTOR
The rear deflector,attached betweenthe rear
wheels ofyour lawnmower,is providedto
minimize the possibilitythat objectswillbe
thrownoutthe rear ofthe lawnmowerintothe
operator's mowingposition.If the rear
deflectorbecomes damaged, itshouldbe
replaced.
TO REMOVE/REPLACE DRIVE BELT
• Remove drivecover. Remove belt by
pushingdownon gear case pulleyand roll
beitoff.
•Tum lawn mower on itsside with carbure-
tor and fuel cap up.
• Remove blade.
• Remove debris shield.
• Remove belt from engine pulley on
crankshaft.
• Install new belt by reversing above steps.
• Alwaysuse factory approvedbelt to assure
fit and longlife.
Belt _[_ _!
Push ImH
downI- Inl/! iii=
TO ADJUST HANDLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
• Remove upper handle and all parts
attached to lower handle.
• Remove hairpin cotters from lower
handle bracket mounting pin.
• Squeeze lower handle in to remove it
from mounting pins.
• Turn lower handle over to raise or lower
handle.
• Squeeze lower handle in and position
holes onto mounting pins on handle
bracket.
• Reassemble upper handle and all parts
removed from lower handle.
Mowing ., Mowing .
position ,_._ position / i'
, !
• a
Low position High position
¥
Rotate
Lower
handle
14
Loading ...
Loading ...
Loading ...