Loading ...
Loading ...
Loading ...
1
Step
Remove
Packaging
2
Step
Prepare
Water
Line
Built-In Refrigerator Installation Steps
CAUTION: Refrigerator is much heavier at the top
than at the bottom–be careful when moving.
● Remove outer carton.
–Carefully cut banding at top and bottom.
–Remove top cap.
-Slide out back corner posts (2).
–Slide carton off top of cabinet.
● Remove toekick from back of refi-igerator and set
aside for later installation.
s Remove grille panel frame from front of door, set
aside for later installation.
NOTE: IT IS NOT NECESSARY TO LAY CABINET
DOWN IN ORDER TO REMOVE SKID!
. To remove skid, remove the four 7/ 16“ bolts and
their brackets.
CAUTION: DO NOT ATTEMPT TO ROLL UNIT
OFF SKID.
c There are support blocks on the bottom of cabinet
and door. They must be removed before rolling
unit off skid or damage will occur.
● Carefully tilt cabinet and slide blocks out from
underneath cabinet, slide unit off skid.
When using a hand-truck, handle from side only.
/
7/1 6“ Bolts
s Route 1/4” OD copper tubing between house
cold water line and the water connection location.
● Copper tubing should be long enough to
extend to the front of the refi-igerator. Allow
enough to accommodate bend leading into the
water valve.
. Install a shut-off valve between the icemaker
water valve and cold water pipe in the base-
ment or a cabinet. The shutoff valve should be
located where it will be easily accessible.
l\
Floor
Copper Tubmgy
&
o
7
——.
Loading ...
Loading ...
Loading ...