Loading ...
Loading ...
Loading ...
Grounding the
IMPORTANT-( Please read carefully)
Appliance
FOR PERSONAL SAFETY, THIS APPLIANCE MUST
BE PROPERLY GROUNDED.
The power cord of this appliance is equipped with a
three-prong (grounding) plug which mates with a
standard three-prong grounding wall receptacle to
minimize the possibility of electric shock hazard from
this appliance.
If the electrical service provided does not meet the
above specifications, it is recommended that a
licensed electrician install an approved outlet.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT
OR REMOVE THE THIRD (GROUND) PRONG
FROM THE POWER CORD.
DO NOT USE AN EXTENSION CORD WITH THIS
APPLIANCE.
DO NOT USE AN ADAPTOR PLUG WITH THIS
APPLIANCE.
Tools
Required
Tinsnips to cut
Level
#2 Phillips screwdriver
7/16” socket with 3“
banding
Appliance Hand Truck
Stubby Phillips
extension for rachet
Stepladder
. Tubing cutter
screwdriver
Safety glasses
c Bucket
7/16” open-end wrench
Drill and appropriate
bits
Hardware
s
1-1/2” stamped open-
. Special plastic fastener
1/4” panel foam spacers
Supplied
end wrench
adhesive strips
. 1/4-1/4 union with nuts
Hardware
Water shut-off valve Water filter
Custom panel for fresh Side panels (see page 8)
Required
(optional but WR97X0214 (optional
food and freezer
Hardware for side
recommended)
but recommended)
compartments.
panel installation
Flooring
For proper installation, this unit must be placed
CAUTION: Protect the
on a level surface of hard material that is at the
finish of the flooring. Cut
same height as the rest of the flooring. This surface
a large section of the
should be strong enough to support a fully loaded
cardboard carton, lay on
refrigerator.
the floor in the area
where you are working.
Door
Clearance
Ii%quired
If the refrigerator is to be installed in a corner:
A 2“ min. clearance between the case trim and
adjacent wall on both sides of the refrigerator will
assure a 90° door opening and access to all drawers.
An 8“ clearance is required on both sides for
removal of pans.
6
Loading ...
Loading ...
Loading ...