Loading ...
Loading ...
Loading ...
Fastenthecabletothelowerhandlewiththetwo
cabletiesfoundonthelowerhandle.Pullthecable
tiestightandtrimofftheexcess.SeeFigure5.
Cable Tie. __
Handle
Figure 5
NOTE: Your mower is shipped with the handle in the
higher position. If you wish to lower the height of the
handle, refer to the Adjustment Section at this time.
AttachingRearWheels(IfNotAIreadyAttached)
• Remove the hex flanged nut on the rear axle from
each side and place the rear wheel on the axle.
Make sure the wave washer is on the inside of the
wheel, between the wheel and the lawnmower. See
Figure 6. Reinsert the flanged nut into the axle as
shown, and tighten securely. Repeat on other side.
Rear Axle
Rear Wheel
\
\
\ Wave Washer
\
\ \
Rex
Nut /
i
Figure 6
AttachingStarterRope
The rope guide is already attached to the right side of
the upper handle of your mower. See Figure 7.
_Wing Nut
/Upper Handle
Starter Ro
Rope Guide
Lower Handle
Figure 7
With the spark plug wire disconnected and
grounded, hold the blade control handle against the
upper handle, and pull the rope out of the engine.
Slip the rope through the rope guide as shown
below. Tighten the wing nut holding the rope guide
to the upper handle.
AssemblingGrassCatcher
NOTE: /f the grass catcher came pre-assembled,
proceed to the next section. If it came unassembled,
follow the steps below to assemble it first, before
attaching to the mower.
Insert frame into grass bag with the black plastic
side on the bottom of bag. See Figure 8.
Slip the openings in the side of the plastic channel
on bag over the hooks on the grass catcher frame.
Secure bag to the frame by working the six plastic
channels on bag over frame. All of the plastic
channels except the center top of the bag attach
from the outside of bag. The center top of the bag
attaches from inside the bag. See Figure 8.
Grass Catcher
*/Frame Insert frame
Plastic
Channel
Grass Catcher
Assembly
Complete
Figure 8
AttachingGrassCatcher& Chute
_1_ WARNING: Never operate the mower
unless the hooks on the grass catcher are
firmly seated on the chute pivot rod, and the
rear discharge door rests firmly against the top
of the grass catcher.
IMPORTANT:Make sure cable is routed to the outside of
the handle so that it is not in the way when attaching the
grass catcher.
• Lift the rear discharge door on the mower.
• Place the hooks, found on both sides of the grass
catcher frame, over the chute door pivot rod at the
rear of the mower. Release the rear discharge door.
See Figure 9.
Loading ...
Loading ...
Loading ...