Troy-Bilt 11A-546N711 21" Hi-Wheel Push Lawn Mower

Operator's Manual - Page 10

For 11A-546N711. Also, The document are for others Troy-Bilt models: 11A-549N711

PDF File Manual, 16 pages, Read Online | Download pdf file

11A-546N711 photo
Loading ...
Loading ...
Loading ...
GrassCatcher
The grass catcher, located at the rear of the mower, is
used to bag the grass clippings for disposal at another
site. Once the bag is full, it has to be removed from the
mower and emptied before any further mowing.
MulchingPlug
Instead of collecting grass clippings in a grass catcher,
this mower has the option of recirculating the clippings
back to the lawn. This is called mulching. Remove the
grass catcher and the side-discharge chute from the
mower, and operate with the mulching plug only for this
purpose.
SECTION5: OPERATINGYOURLAWNMOWER
_ ARNING: Read, understand, and follow all
instructions and warnings on the machine and
in this manual before operating.
NOTE: You must service the engine with oil and
gasoline before starting the mower for the first time.
Check oil and gasoline levels and fill up as necessary
for subsequent starts.
Gas& OilFill-Up
Check oil level and add oil if necessary. Follow
relevant instructions in the engine manual for this.
Service the engine with gasoline as instructed in
the engine manual.
_ ARNING: Use extreme care whenhandling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Never
fuel the machine indoors or while the engine is
hot or running. Extinguish cigarettes, cigars,
pipes and other sources of ignition.
BeforeStartingMower
Attach spark plug wire to spark plug. Make certain
the metal cap on the end of the spark plug wire
(inside the rubber boot) is fastened securely over
the metal tip on the spark plug.
StartingEngine
(On Model 549 only, Model 546 skip to next bullet
point) Push primer three times. Wait about two
seconds between each push. In cold weather
around 55° F or below, prime five times. Do not
prime to restart a warm engine after a short
shutdown.
Standing behind the mower, depress the blade
control handle and hold it against the upper handle.
Grasp starter handle and pull rope out slowly until
engine reaches the start of compression cycle
(rope will pull slightly harder at this point). Let the
rope rewind slowly.
Pull rope with a rapid, continuous, full arm stroke.
Keeping a firm grip on the starter handle, let the
rope rewind slowly.
_ WARNING: Be sure no one other than theoperator is standing near the lawn mower while
starting engine or operating mower.
WARNING: Never run engine indoors or in
enclosed, poorly ventilated areas. Engine
exhaust contains carbon monoxide, an
odorless and deadly gas.
WARNING: Keep hands, feet, hair and
loose clothing away from any moving parts on
engine and lawn mower.
NOTE: See your engine manual packed with your unit
for more detailed instructions.
StoppingEngine
Release blade control handle to stop the engine
and the blade.
Disconnect spark plug wire and move away from
spark plug to prevent accidental starting.
UsingYourLawnMower
You can use your mower as a mulching mower or a
rear bagger.
Be sure that the lawn is clear of stones, sticks, wire,
or other objects which could damage lawn mower
or engine.
_ ARNING: If the mower strikes a foreign
object, stop the engine. Remove spark plug
wire from the spark plug and thoroughly inspect
for any damage. Repair the damage promptly
before restarting and operating the mower.
Forbest results, do not cut wet grass. New grass or
thick grass may require a narrower cut.
10
Loading ...
Loading ...
Loading ...