Loading ...
Loading ...
Loading ...
/
CHUTE CRANK
ASSEMBLY
5/16" LOCK
WASHER
5/16" HEX NUT
FIGURE 18
_16"FLAT
WASHER --_
LEFT SIDE VIEW
• Coat the top of the ring around the discharge
opening with general purpose grease. See figure 19.
• Place the discharge chute (facing forward) onto the
discharge opening, aligning the crank rod spiral
with the notches in the chute flange.
• Attach the three chute keepers (right side up as
shown in figure 19) and the anti-rotation bracket to
the bottom of the chute flange. Use six 1/4" x 1"
hex bolts, 1/4" flat washers and 1/4" flanged lock
nuts. Tighten carefully so that the plastic parts are
not deformed. See figure 19.
• Place the plastic grip onto the back end of the anti-
rotation bracket. See figure 19.
• Position the chute crank assembly so that the crank
rod spiral does not rub the bottoms of the notches
in the chute flange and then tighten the nuts left
loose in figure 19.
• Check if the crank rod rotates the chute freely. If
not, loosen by 1/4 turn each the six flanged nuts
holding the chute keepers to the chute flange.
FLANGE
GREASED
SURFACE
PLASTIC
GRIP
ANTI-ROTATION
BRACKET
1/4" FLANGED
LOCK NUT j
JJ
MOUNTING SNOW THROWER TO TRACTOR
NOTE: The help of another person may be required to
mount the snow thrower to the front of the tractor.
• Place the tractor and snow thrower on a flat, level
surface.
• Remove the plastic tie from the auger belt and
extend the belt out behind the snow thrower,
making sure the belt remains assembled around
the top of the large auger drive pulley and passing
underneath the two side idler pulleys.
• Align the tractor behind the snow thrower.
• Remove the attachment pin from the snow thrower.
• Squeeze the release trigger on the lift handle and
raise the handle out of the locked position. (If the
handle will not release out of the locked position,
refer to the Service and Adjustments section of this
manual.)
• Grasp the round bar just behind the auger drive
pulley and lift up to align the rear mounting notches
on the snow thrower with the mounting pins on the
tractor. Slide the pins into the notches.
HINT: If you are unable to fit the mounting pins into
the notches, try placing 1" or 2" blocks of wood
under the front skid shoes on the snow thrower.
• Assemble a 3/4" washer and a 1/8" hairpin ctip to
each mounting pin.
• Secure the snow thrower to the tractor using the
attachment pin and 1/8" hairpin clip. Insert the
attachment pin from the left side. See figure 20.
[]
ATTACHMENT PIN
1/8" HAIRPIN CLIP '''''v"
/
3/4" FLAT
WASHER
FIGURE 20 RIGHT SIDE VIEW
FIGURE 19 RIGHT FRONT CORNER VIEW
11
Loading ...
Loading ...
Loading ...