Loading ...
Loading ...
Loading ...
Assembling Your Tilt-Head Stand Mixer
To Attach Bowl
1. Turn speed control to "0."
2. Unplug Stand Mixer or disconnect
power.
3. Hold the locking lever in the UNLOCK
position and tilt motor head back.
4. Placebowl on bowl clamping plate.
5. Turn bowl gently in clockwise
direction.
To Remove Bowl
1. Turn speed control to "0."
2. Unplug Stand Mixer or
disconnect power.
3. Hold the locking lever in the UNLOCK
position and tilt motor head back.
4. Turn bowl counterclockwise.
To Remove Flat Beater,
Wire Whip, or Dough Hook
1. Turn speed control to "0."
2. Unplug Stand Mixer or disconnect
power.
3. Hold the locking lever in the UNLOCK
position and raise motor head.
4. Pressbeater upward as far as possible
and turn left.
5. Pull beater from beater shaft.
ii
To
1.
2.
3.
Lock Motor Head
Make sure motor head is completely
down.
Place locking lever in LOCKposition.
Before mixing, test lock by attempting
to raise head.
To Unlock Motor Head
1. Place lever in UNLOCK position.
NOTE: Motor head should always be
kept in LOCKposition when using the
Stand Mixer.
To Attach Flat Beater,
Wire Whip, or Dough Hook
1. Turn speed control to "0."
2. Unplug Stand Mixer or disconnect
power.
3. Hold the locking lever in the UNLOCK
position and raise motor head.
4. Slip beater onto beater shaft and press
upward as far as possible.
5. Turn beater to right, hooking beater
over pin on shaft.
To Operate Speed Control
Plug Stand Mixer in proper electrical
outlet. Speed control lever should always
be set on lowest speed for starting, then
gradually moved to desired higher speed
to avoid splashing ingredients out of bowl.
See "Speed Control Guide" section.
Loading ...
Loading ...
Loading ...