Loading ...
Loading ...
Loading ...
Assembling Your Bowl-Lift Mixer
ilil
i:
Pin
To Remove Fiat Beater,
Wire Whip, or Dough Hook
1. Turn speed control to "O."
2. Unplug Stand Mixer or disconnect
power.
3. Lower bowl by rotating bowl-lift
handle downward.
4. Pressbeater upward and turn right.
5. Pull beater from beater shaft.
Stand Mixer Speed Control
To reduce the potential for splash-out,
always begin mixing using Speed 1 (STIR
speed), then gradually move to higher
speeds as needed. See "Speed Control
Guide."
Auto-Reset Motor Protection
If the Stand Mixer stops due to overload,
slide the speed control lever to "0."
After a few minutes, the Stand Mixer will
automatically reset. Slide the speed control
lever to the desired speed and continue
mixing.
If the Stand Mixer does not restart, see
"When You Need Service."
Assembling Your Pouring Shield*
Chute
To Attach Pouring Shield
1. Turn speed control to "O."
2. Unplug Stand Mixer or disconnect power.
3. Attach flat beater, dough hook, or wire
whip and bowl (depending on your
model, see "AssemblingYour Tilt-Head
Stand Mixer" or "AssemblingYour Bowl-
LiftMixer").
4. Fromthe front of the Stand Mixer,slide
the pouring shield overthe bowl until the
shield is centered.The bottom rim of the
shield should fit within the bowl.
To
1.
2.
3.
4.
To
1.
2.
Remove Pouring Shield
Turn speed control to "O."
Unplug Stand Mixer or disconnect power.
Lift the front of the pour shield clear of
the bowl rim and pull forward.
Remove accessory and bowl.
Use Pouring Shield
For best results, rotate the shield so the
motor head covers the "u" shaped gap
in the shield. The pouring chute will be
just to the right of the accessory hub
asyou face the Stand Mixer.
Pour the ingredients into the bowl
through the pouring chute.
* If Pouring Shield is included.
11
Loading ...
Loading ...
Loading ...