Loading ...
Loading ...
Loading ...
Section 5: Maintenance
An O-Ring Maintenance Kit is provided with your pressure
washer which includes replacemeut o-rings, rubber washer
and water inlet filter. Refer to the instruction sheet provided
in the kit to service your unit's o-rings, Note that not all of
the parts in the kit will be used on your unit.
To remove a worn or damaged o-ring, use a small flathead
screwdriver to get underneath the o-ring and pry it off'.
Pump Maintenance
Changing Pump Oil
Change oit every 50 hours or once yearIy, whichever
occurs first,
NOTE:You must purchase a premeasured bottle of pump
oil, item number 190586GS, by contacting the nearest
authorized service center.
Change pump oil as follows:
I. Drain engine oil and fuel from pressure washer.
2. Use a 8mm allen wrench to remove black pump oil cap
between high pressure outlet and garden hose inlet
(Figure 15).
Oii Cap
3. Tilt pressure washer to drain oil into an approved
container until it drips slowly from pump.
4. Tilt pressure washer in opposite direction and empty
premeasured pump oil bottle into same opening (a
small funnel may be helpful).
5. Install black pump oil cap and tighten firmly.
6. Set pressure washer in upright peairJon.Add fuel and
engine oil.
ENGINE MAINTENANCE
See the engine owner's manual for instructions on how to
properlymaintain the engine.
• Thoroughly wash exposed areaswith soap and water,
KEEPOUT OF REACH OF CHILDREN, DON'T
POLLUTE.CONSERVE RESOURCES.RETURN
USED OIL TO COLLECTION CENTERS.
Data Plate
Data plate information is very important if you need help from
our Customer Service Department or an authorized service
dealer,
• The data plate (Figure 16) is located on the base of the
pressure washen For future reference, please copy the
model, revision, and serial number of the pressure washer
in the space below.
, Copy Model
Number Here
MOD_EL
] Copy Revision
HereREV NO
SERIIAL
GPM
Copy Ser a
i Number Here
E
E
m
Loading ...
Loading ...
Loading ...