Loading ...
Loading ...
Loading ...
7
REV 2 - 1401030955
L-C2-356
Air shutters are preset at the factory based on the
gas the sideburner is built to burn. However, altitude
or other local conditions may require air shutter
adjustment for proper combustion.
The fl ames from a properly adjusted sideburner
will touch the burner ports and appear mostly blue.
If they are orange, “lazy,” or lift off the burner ports,
then adjust the sideburner air shutter using the
following steps.
The air shutters are located at the end of the burner
assemblies, behind the control panel. They can
safely and easily be adjusted while the unit is lit.
CAUTION: Do not touch the sideburner
surrounding top area, as it will be
hot while adjusting the air shutter.
1. Remove the control knobs and screws fi rst,
then carefully lift away the control panel.
Important: Prior to fully removing the control
panel, you must disconnect the
battery holder assembly wires that
are located behind the control panel.
2. Replace the control knobs back on to the valve
stems
.
3.
Light the sideburner following the LIGHTING
INSTRUCTIONS section.
4. Loosen the front burner air shutter adjustment
screw, then use the tip of a screwdriver to open
or close the air shutter until the fl ames appear
blue and touch the burner ports.
5. Retighten the adjustment screw.
6. Repeat for rear burner air shutter.
Should you have difficulty accessing
the rear burner air shutter, you may shut
down, remove the rear burner (when cool),
then adjust the air shutter to the same
opening as the already adjusted front
burner. (See INSTALLATION section to
remove rear burner.) Be sure to properly
reinstall rear burner when complete.
7. Once all adjustments are complete; be sure
the unit is off and remove the knobs, then
replace the control panel, being sure to
reconnect the battery holder assembly wires.
Replace the control knobs.
The valve, igniter, and burner on your double sideburner have been pre-assembled and tested before
shipping. We suggest you follow and practice these instructions for safe lighting of your double sideburner.
Each time you use your double sideburner, ensure that:
1. The area around the unit is clear and free from gasoline and other fl ammable vapors, liquids,
and materials.
2. There is no blockage of air fl ow around the burner.
3. When using propane gas:
a. The special ventilation openings in the enclosure are kept free and clear of debris.
b. If connected to a propane cylinder, the rubber hose attached to the regulator is carefully
inspected before each use.
c. The propane cylinder, regulator, and rubber hose are installed in a location not subject to
heating above 125° F (51° C).
4. Burner fl ames are burning evenly around the burner cap with a steady fl ame (mostly blue). A
proper fl ame pattern will ensure safe operation and optimal performance. See AIR SHUTTER
ADJUSTMENT section.
Do not operate the burner with the cover in place.
SAFETY TIPS
AIR SHUTTER ADJUSTMENT
Fig. 7-2
Close
Open
Fig. 7-1
Loading ...
Loading ...
Loading ...