Loading ...
Loading ...
Loading ...
Installation Instructions
[] ADJUST BROIL AND OVEN
BURNER AIR ADJUSTMENT
SHUTTERS IF NECESSARY
Air adjustment shutters for the top and bottom burners
regulate the flow of air to the flmnes.
The air a(!iustn_ent shutter fin" the top (broil) burner is
in the center of the rear wall of the oxen.
Jstment
shutter
I
The shutter fl)r the bottom (oxen) burner is near the
back wall behind the warming drawer. Remoxe the
drawer. See the Care and cleaning of the range section.
To adjust the flow of air to either burner, loosen the
Phillips head screw and rotate the shutter toward open
or closed position as needed.
The flames for the top (broil) burner should be steadx
with approximately l" blue cones and should not
extend out oxer the edges of the burner battle.
To determine if the bottom burner flames are burning
properl B remove the oven bottom. [qames should have
approximately l" blue cones and, if range is sui)plied
with natural gas, should burn with no yellow tipping.
(_A]th most I,P gas, small yellow tips at the end of outer
cones are normal.) Flames should not lilt oft bm'ner
ports. If lilting is observed, gradually reduce air shutter
opening until flames are stabilized.
[] ADJUST BROIL AND OVEN
BURNER AIR ADJUSTMENT
SHUTTERS IF NECESSARY (CONT.)
Oven
\
To remove the oven bottom:
A. Remove the knurled screws holding down rear of the
o_,en bottom.
B. (;rasp the oxen bottom at finger slots on each side.
C. i,ilt the rear of the oven bottom enough to clear the
lip of the range frame, push it back, and then pull it
up and out.
[] LEVELING THE RANGE
a.
range where it will be installed.
Raise
| _aO:_r range
range
Install the oven shelves in the oven and position the
Lower
range
(on some models) (on some models)
B. Check tot levelness by placing a spirit level or a cup,
partially filled with water, on one of the oven shelves.
If using a spirit level, take two readings--with the
level placed diagonally first in one direction and
then the other.
C.
D.
Remove the drawer. See the Care and cleaning of the
range section. The fl'ont leveling legs can be a(!justed
fl'om the bottom and the rear legs can be a(!justed
fl'om the top or the bottom.
Use an open-end or a(!iustable wrench to a(!iust the
lexelin,,_ legs until the ranoe_ is lexel.
E. After the range, is level, slide the ranoe_ away from the
wall so that the Anti-Tip dexice can be installed.
52
Loading ...
Loading ...
Loading ...