Loading ...
Loading ...
Loading ...
Hints and Care
How to Remove and Replace Light Bulb .....
-_ How to Get the
] _/Most Out of
Your Energy
Dollar
[ ark WARNING
To avoid electrical shock which can cause severe personal injury or death,
disconnect power to refrigerator before replacing light bulb. After replacing light
bulb, connect power.
[ CAUTION
To avoid personal injury or property damage, observe the following:
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
• When placing refrigerator into final
position, allow for 1" clearancearound the top and sides of unit
to supply ample ventilation for
mmm
optimum energy efficiency.
• Avoid overcrowding refrigerator
shelves. This reduces effectivity of
air circulation around food and
causes refrigerator to run longer.
• Avoid adding too much warm food _1_
to unit at one time. This overloads _11
compartments and slows rate of
cooling.
• Do not use aluminum foil, wax
paper, or paper toweling as shelf
liners. This decreases air flow and
causes unit to run less efficiently.
• A freezer that is 2/3full runs most
efficiently.
Freezer section
1. Pinch rear tabs (,4) on light cover and pull
straight out.
2. Remove light bulb.
3. Replace bulb with appliance bulb no greater
than 40 watts.
4. insert top tabs (B) of light cover into refrigerator
liner and snap back portion over light assembly.
A
B
Locate refrigerator in coolest part
of room. Avoid areas of direct
sunlight, or near heating ducts,
registers, or other heat producing
appliances. If this is not possible,
isolate exterior by using a section
of cabinet or an added layer of
insulation.
Refer to use and care guide
section on temperature controls
for recommended control
settings.
Clean door gaskets every three
months according to use and
care guide instructions. This will
assure that door seals properly
and unit runs efficiently.
• Take time to organize items in
refrigerator to reduce time that
door is open.
Be sure your doors are closing
securely by leveling unit as
instructed in your owner's
manual.
]5
Clean condenser coils off as
indicated in the use and care
guide every 3 months. This will
increase energy efficiency and
cooling performance.
Loading ...
Loading ...
Loading ...