Loading ...
Loading ...
Loading ...
TROUBLESHOOTi POINTS
PROBLEM
H . ,
Engine continuesto run
when operatorle_ws seat
with a_aohmentciutch
engaged
Poorcut-uneven
Mower blades wig not
rotate
Poor grass discharge
Headlight(s) not working
(if so equipped)
Battery will not charge
Engine "backfires"
when turning engine
"OFF"
CAUSE
1. Fealty op_rator-safety presence control system
1. Worn. bsntor loose blade.
2. Mower deck not level,
3, Buildup of grass, leaves, and trash undor mower.
4, Bent blade mandrel.
5. Clogged mower deck vent holes from buildup of
grass, leaves, and trash around mandr_ls,
1. Obstruction in clutch mechanism,
2, Worn/damaged mower drive belt.
3, Frozen idler pulley.
4. Frozen blade mandref,
1, Engine speed too slow.
2. qravei speed too fast.
3. Wet grass.
4. Mower deck not level.
5. Low/uneven tire air pressure,
6, Worn, bent or loose olade.
7. Buildup of grass, !_aves and trash under mower.
8. Mower drive belt worn.
9. Blades improperly installed
10, Impro0er blades used.
1. Clogged mower deck vent holes from buildup of
grass, leaves, and trash around mandrels.
1 Switch is "OFF".
2, Bulb(s) burned out
3. Faulty light switch.
4. Loose or damaged wiring.
5. Blown fuse.
1. Bad battery cell(s).
2. Poor cable connections.
3. Faulty regulator (if so equipped).
4. Faulty alternator.
1. Engine throttle control not set at "SLOW"
position for 30 seconds before stopping engine.
CORRECTUON
1. Chect wiring, ;witches ar, d connectJor_s. _f not
corrected, car;loci an authorized service cent(÷r,r
department,
1. Replace blade. Tighten blade bolt.
2, Leveimower deck.
3, C,leart underside o mower housing.
4. Replace _lade mandrel
5. Cean around mandrels to open vent holes.
1. Remove obstruction.
2, Replace mower drive b.Jt,
3. Replace idler pulley.
4. Replece blade mandrei.
1. Place throttle control in "FAST" position.
2. Shift to slower speed.
3. Allow grass to dry before mowing.
4, Level m_:w_r deck
5. Check tires for proper air pressure.
6. Repiace/sharpen blade, Tighten blade bolt.
7. Clean underside rff mower housing,
8. Replace mower drive belt.
9. Reinstall blades sharp edge down.
!0. Replace with blades listed in this manual.
11. Clean around mandrels to open vent holes.
1. Turn switch"ON".
2. Repiac,; bulb(s).
3, Check/replace light switch.
4. Check widng and connections,
5. Replace fuse.
1. Replace battery.
2. ChecWclean all connections,
3. Replace regulator.
4. Replace alternator.
1. Move throttle control to "SLOW" position and allow
to idle for 30 seconds before stopping engine.
28
Loading ...
Loading ...
Loading ...