Loading ...
Loading ...
Loading ...
Aboutthe temperaturecontrols. GEAppliances.com
The temperature controls are preset in the factory at 37°1:for the
refrigerator compartment and O°Ffor the freezer compartment. Allow
24 hours for the temperature to stabilize to the preset recommended
settings.
The temperature controls can display both the SET temperature
as well as the actual temperature in the refrigerator and freezer.
The actual temperature may vary slightly from the SET temperature
based on usage and operating environment.
Setting either or both controls to OFFstops cooling in both the freezer
and refrigerator compartments, but does not shut off electrical power
to the refrigerator.
NOTE: The refrigerator is shipped with protective film covering the
temperature controls. If this film was not removed during installation,
remove it now.
Tochange the temperature, press and release the
WARMER or COLDERpad. Tile SETlight will come
on and tile display will show tile set temperature.
To change tile temperature, tap either tile
WARMER or COLDERpad tlntil tile desired
temperature is displayed. Refl_igerator temperatm'es
can be at!lusted between 34°F and 44°F and tile
fl'eezer temperatm'es can be a(!justed between
-6°F and +6°E
Once tile desired temperature has been set,
tile temperature display will return to tile actual
refl-igerator and fl'eezer temperatm'es after 5
seconds. Several ac!iusnnents may be required.
Each tilne you ac!itlSt controls, allow 24 hotli'S tk)r tile
refl-igerator to reach tile temperatm'e you have set.
Toturn the cooling system off,tap tile WARMER pad
tot either the reti_igerator or the fl'eezer until the
display shows OFF.To turn the unit back on, press the
COLDER pad fin" either the refl_igerator or fl'eezer.
The SETlight will illuminate on the side wm
selected. Then press the COLDERpad again (on the
side where the SETlight is illuminated) and it will
go to tile preset points of O°FfOr tile fl'eezer and
37°FtOr tile refl-iger:mn: Setting either or both
controls to OFFstops cooling in both the fl'eezer
and refrigerator compartments, but does not shut
off electrical power to tile refl_igerato_:
PerformanceAir Flow System
Tile Perl0mmnce M_=Flow System is designed to
maximize temperature control in tile refrigerator
and fl'eezer comlxmments. This unique special
featm'e consists of tile Mr Tower along tile back
wall of tile refrigerator and tile Mr Tmmel on tile
bottom portion _fftile fl'eezer rear wall. Placing food
in fl'ont of tile lou\'e_ on these components will not
affect pe_fommnce. Mthough tile Mr Tower and
the Mr Tmmel can be removed, doing so will affect
temperatm'e i)e_fomlance. (For remox_d
instructions, onqine, 24 horns a da> contact us at
GEAl)pliances.com or call 800.GE.( ;ARES. In
Canada, contact us at geappliances.ca or call
1.800.361.3400.)
Loading ...
Loading ...
Loading ...