Loading ...
Loading ...
Loading ...
Removingand replacing the doors.
When installing or moving the refrigerator, the doors may need to be removed in order to fit the refrigerator
through a doorway.
Removing the Doors
Make sure the doors are closed and the refrigerator
is unplugged.
0 Disconnect water line and wiring harness.
Near the lower hinoe_ on the fl'eezer side, push in on
the collm_ at each end ot the coupling, and pull the water
line robing fl'on/the coupling. _Mso, (liscmmect wiring
harness. Pull the water line and the harness through the
lower rail.
0 Remove the hinge covers and the hinges.
In order to access the hinges, the hinge covers need to
be removed. Remove the cover by grasping it on the sides,
near the back of the covei: Push back on the cover and
lift up at the back, then the front.
NOTE: DONOTuse a screwdriver to remove the cover BECAREFUL
not to break the rear retaining tab on the hinge cover Removethe
hbges usbg a TorxT-20.
Remove the doors.
(:arefhllv rotate the door to 90? (;uiding the disconnected
water line and wiring harness, lift the door straight up.
NOTE: Not/i@bg the doorstraight up may damagethe bottom hinge.
Piece doors on a protectedsurface.
NOTE: Be careful not to pinch the water tubing and the wire harness
at thebottom of the door
NOTE: Donot allow the connectorto contact the floor Hardcontact
can damage the connector See "Replacingthe Doors."
Replacing the Doors
Place doors on bottomhinges.
_Mth the door at 90 ° lower the door straight down onto
the bottom hinge. Careflflly close the (loo_:
NOTE: Not/owenng the doorstraight down onto thebottom hinge
may damage the hinge.
NOTE'.Donot allow the connectorto contact the floor Hardcontact
can damage the connector
Replace top hinges and hinge covers.
Reinstall the top hinges using a Torx T-20. Replace the
hinge covers. If the doms are not level, a@_st the bottom
right hinge with a 7/16" open ended wrench.
_) Reconnect water line and wiring harness.
Insert water tubing back into coupling, making sure the
tubing is pushed flu" enough into the coupling so that you
no longer see the mark on the robing. Recmmect the
wiring harness.
Turn on the water supply and plug the refrigerator hack in.
WireHarness%
-- HingeCover
Door
HingePin
Connector
23
Loading ...
Loading ...
Loading ...