Loading ...
Loading ...
Loading ...
Usin the self-cleanin oven.
Wipe up heavy soil on the oven
bottom.
Before a Self-Clean Cycle
[A WARNING i
FIREHAZARD:Wipe grease and heavy soil
from the oven bottom before self-cleaning.
Failure to do so may result in an oven fire.
We recommend venting your kitchen with
an open window or using a ventilation fan or
hood during the first self-clean cycle.
Remove any broiler pan, broiler grid, probe,
all cookware and any aluminum foil from the
oven.
NOTE:
If your oven is equipped with shiny, silver-
colored oven racks, we recommend
you remove them before you begin the
self-clean cycle. They may remain in the
oven during the self-clean cycle, but they
will darken, lose their luster and become
hard to slide.
If your oven is equipped with gray
porcelain-coated oven racks, they may be
left in the oven during the self-clean cycle.
Soil on the front frame of the range and
outside the gasket on the door will need to
be cleaned by hand. Clean these areas with
hot water, soap-filled steel-wool pads or
cleansers such as Soft Scrubl Rinsewell with
clean water and dry.
Do not clean the gasket. The fiberglass
material of the oven door gasket cannot
withstand abrasion. It is essential for the
gasket to remain intact. If you notice it
becoming worn or frayed, replace it.
Make sure the oven light bulb cover is in
place and the oven light is off.
IMPORTANT'.The health of some birds is
extremely sensitive to the fumes given off
during the self-cleaning cycle of any range.
Hove birds to another well-ventilated room.
Canadian Models Only:
The surface units are automatically disabled
during the self-clean cycle. Make sure that
all surface unit controls are turned off at
all times during the self-clean cycle. Any
surface unit that is set to an "on" position
while the self-clean cycle is operating will
automatically come on after the self-clean
cycle is finished, and could result in an "on"
unattended surface unit. Wait until the
self-clean cycle is finished to set and use the
surface units.
DDD D
@DD N1
How to Set: the Oven for Self-Cleaning
The oven door must be closed and all controls
set correctly for the cycle to work properly.
[-_ Touch the SELFCLEAN pad.
If a time other than the default time is
needed, use the number pads and
enter the desired clean time.
You can change the clean time to any time
between 3 hours and S hours, depending on
how dirty your oven is.
[_ Touch the START pad.
The oven door locks automatically. The
display will show the clean time remaining.
It will not be possible to open the oven door
until the temperature drops below the lock
temperature and LOCKED goes off in the
control display.
The word LOCKEDwill flash and the word
DOORwill display if you set the clean cycle
and forget to close the oven door.
To stop a clean cycle, touch the CLEAR/
OFF pad. When LOCKEDgoes off,
indicating the oven has cooled below the
locking temperature, you will be able to
open the door.
20
Loading ...
Loading ...
Loading ...