Craftsman 315272070 1/2" professional cordless drill/driver

User Manual - Page 7

For 315272070.

PDF File Manual, 22 pages, Download pdf file

Loading ...
Loading ...
Loading ...
_1, WARNING: Always wear safety goggles or
safety glasses with side shields when operating
tools. Failure to do so could result in objects
being thrown into your eyes, resulting in possible
serious injury.
_, WARNING: Do not allow familiarity with your
drill-driver to make you careless. Remember that
a careless fraction of a second is sufficient to
inflict severe injury.
CHARGING YOUR DRILL-DRIVER
The battery pack for this tool has been shipped in a
low charge condition to prevent possible problems.
Therefore, you should charge it until light on front of
charger changes from red to green.
Note: Battedes will not reach fullcharge the first time
they are charged. Allow several cycles (drilling
followed by recharging) for them to become fully
charged.
TO CHARGE
Charge battery pack only with the charger
provided.
Make sure power supply is normal house
voltage, 120 volts, 60 Hz, AC only.
Connect charger to power supply.
Place battery pack in charger aligning raised ribin
charger with groove in battery pack.
Press down on battery pack to be sure contacts on
battery pack engage propedy with charger
contacts.
Red lightshould turn on. Red light indicates fast
charging mode.
If red light is flashing, this indicates battery pack is
deeply discharged or hot.
If battery pack is hot, red light should become
steady after battery pack has cooled down.
If battery pack is deeply discharged, red light should
become steady after voltage has increased,
normally within 30 minutes.
If after one hour red lightis still flashing, this
indicates a defective battery pack and should be
replaced.
Green light on indicates battery pack is in slow
charging mode or fully charged.
Yellow light on and red light flashing indicates
defecta*vebattery pack. Return battery pack to your
nearest Sears Repair Center for checking or
replacing.
When your battery pack becomes fully charged, the red
lightwill tum OFF andthe green lightwill rum ON.
If you remove battery pack from charger and
relnsert It Immediately (leas than 5 seconds)
back In charger, the green light will come on
indicating full charge and slow charging mode
until removed from charger. If you remove
battery pack from charger and walt more than 5
seconds before relnserting It back in charger,
the charger will function normally.
After normalusage, 1 hourofchargingtime isrequiredto
befully charged.A minimum chargelimeof 1-1/2 hours
is requiredto rechargea completelydischargedtool.
The battery packwillbecomeslightlywarmtothe touch
whilecharging.Thisisnormalanddoes not indicatea
problem.
Do not place charger in an area of extreme heat or
cold. It willwork best at normal room temperature.
,_ CAUTION: Your drill-driver contains special high
temperature batteries to help prevent battery
damage when left on charge for extended pedods
of time. However, once the batteries become fully
charged, we recommend that you unplug your
charger from power supply and remove the
battery pack.
LED FUNCTION OF CHARGER
LED WILL BE LIGHTED TO INDICATE STATUS OF CHARGER AND BATTERY PACK:
1. Red LED Lighted = Fast Charging Mode.
2. Green LED Lighted = Slow Charging Mode and Fully Charged Battery Pack.
3. Red LED Flashing = Hot or Deeply Discharged Battery Pack. Also Defective
Battery Pack After 1 Hour.
4. Yellow LED Lighted and Red LED Flashing = Defective Battery Pack.
7
Loading ...
Loading ...
Loading ...