Loading ...
Loading ...
Loading ...
OCCURRENCE POSSIBLE CAUSE / SOLUTION
Oven smokes excessively during broiling. Meat too close to the broil burner. Reposition the rack to provide more clearance between
the meat and the broiler.
Meat not properly prepared. Remove excess fat from meat. Slash remaining fatty edges
to prevent curling, but do not cut into the lean.
Broiler pan used without insert or insert covered with foil. DO NOT use the broiler pan
without the insert or cover the insert with foil.
Broiler drawer needs to be cleaned. Excessive smoking is caused by a build up of grease
or food spatters. If the broiler is used often, clean on a regular basis.
Broiler drawer is open. Drawer/door should be closed when broiling.
Oven Control Errors
This oven is equipped with a state of the art electronic oven controller. Among its many
features isa full time oven circuit diagnostics system. The controller constantly monitors
itsinternal circuitry as well as several crucial oven circuits to insure they are all operating
correctly. If at any time one of these systems fails, the controller will immediately stop
operation, and beep continuously (flashing an error code of F1, F3 or F9* in the display
window, if equipped).
*Oven control beeps and displays F1, F3 or Electronic control has detected afault condition. Press CLEAR to clear the display and stop
Fg. beeping. Reprogram oven. Iffault recurs, record fault number. Press CLEAR and contact
an authorized servicer.
Many factors affect baking results. Make sure the proper rack position is used. Center
Poor baking results, food in the oven and space pans to allow air to circulate. Allow the oven to preheat to the
set temperature before placing food in the oven. Try adjusting the recipe's recommended
temperature or baking time. If you feel the oven is too hot or cool, see Adjusting Your
Oven Temperature in this Use & Care Manual.
Self*Cleaning cycle does not work. Controls are not set properly. Follow instructions in Self*Cleaning section.
Soil is not completely removed.
Self-cleaning cycle was interrupted. Stop time must be set 2to 4 hours past the start time.
Follow steps under "Stopping or Interrupting a Self-Clean Cycle" under Self Cleaning,
Failure to clean bottom front, top of oven or door areas outside oven seal. These areas
are not in the self-cleaning area, but get hot enough to burn on residue. Clean these areas
before starting the self-clean cycle. Burned-on residue may be cleaned with a stiff nylon
brush and water or a nylon scrubber. Be careful not to damage the oven gasket.
Excessive spillovers in oven. Set self-clean cycle for a longer cleaning time.
Flames inside oven or smoking from vent. Excessive spillovers in oven. This is normal, especially for pie spillovers or large amounts
of grease on the oven bottom. Wipe up excessive spillovers before starting the self-clean
cycle. If flames or excessive smoke are present, stop the self-clean cycle and follow the
steps under "Stopping or Interrupting the Self-Clean Cycle" inthe Self Cleaning section.
22
Loading ...
Loading ...