Loading ...
Loading ...
Loading ...
!!i Ii liii¸III lilill,liiiiili,i ilill li!iiilli!i!iiltii/i!
Installation instructions
3-wke connections
Use approved 3--wire Power Supply Cord or a 3-wire Cable for Direct Wiring as described on
page 2S.
1 Remove the terminal block cover plate,
2 Insert the power cord wi@ a UL listed strain relief through the hole provided in the cabinet near }:
the terminal block. Do not tighten strain relief screw until wiring cormections are complete.
Note: a strain relief must be used. _@
,°-
@
.................................................................................Fig.23 nowe,'core/
3 Loosenorremovethecenterterminalblockscrew.Connecttheneutralwire/center/ofthe
power supply cord to the center terminal screw of the terminal block. Tighten screw,
Cor,r,ec__heotherw_resto_heupperand,owerterm_r,a,_,oc_screwsmar_odw_ththe,ether_.
Tighten screws.
4
5 tefit terminal block cover by inserting the two tabs first on the rear panel of the dryer. Secure
cover with securing screw.
6 Tightenstrainreliefscrews.
....... s _ - 6 iii
Fig 25 Refitting terminal block cover Fig2d Tightening strain relid screws
Loading ...
Loading ...
Loading ...