Loading ...
Loading ...
Loading ...
9 Copyright © Puretec Pty Ltd 2019 Puretec Sparq S4 User Guide
Installation
11. Attach the Wiring Loom from the tap to the unit (see Fig.3).
12. Connect the power cord (DO NOT TURN POWER ON).
DO NOT turn on the water/and or power supply, this will be done in Step 22-26 of
Cold/Ambient Water Startup on Page 10.
13. Position the CO
2
bottle as close to the unit as possible, ensuring the bottle is upright.
NOTE: Bottles should always be upright during storage and transit. If the bottle
has been le horizontal, place upright and let stand for 60 minutes for contents
to settle before initialising.
The SPARQ-CO
2
is NOT rellable.
14. Ensure regulator is o by turning the shut-o valve into the closed position.
15. Connect the CO
2
bottle to the regulator. Screw the regulator on rmly (warning: some
CO
2
will escape as the valve in the bottle is depressed).
16. Attach the BLACK tube to the CO
2
connection at the back of the unit and CO
2
bottle
(See Fig.2).
DO NOT open the regulator, this will be done in Step 27 of Soda/Sparkling Water
Startup on page 11.
17. Double check all tubes have been connected properly.
18. Check all plumbing ttings have been tightened and all tubing is connected rmly.
19. Ensure there is adequate ventilation around the unit (150 mm).
20. Check all tubes from the undersink unit to the tap, ensure there are no sags or kinks in
the hoses, and any tube sag is minimised as it can cause ow to be reduced.
Loading ...
Loading ...
Loading ...