Loading ...
Loading ...
Loading ...
13 Copyright © Puretec Pty Ltd 2019 Puretec Sparq S4 User Guide
Gas Replacement
Gas Replacement - As Required
1. Close regulator, turn o soda button and water supply.
2. Purge sparking lines by pressing the sparkling button for 30 sec.
3. Disconnect regulator from BLACK tubing.
4. Unscrew the regulator from CO
2
bottle (turn the regulator anti-clockwise).
5. Connect regulator to new CO
2
bottle (turn the regulator clockwise).
6. Connect BLACK tubing to regulator.
7. Open the regulator and turn on the soda switch (at rear of the unit).
8. Purge the soda line for 1-2 minutes by operating the sparking/soda button on the tap
until the water ow stops and only CO
2
comes out.
9. Restore the water supply and allow 1-2 minutes for the lines to rell.
10. Operate the sparkling water button on the tap for 30 seconds or until excess CO
2
has
been dispensed.
11. Your Puretec system is now ready for use. It may require an hour or two for the
sparkling water to reach full "zz".
Loading ...
Loading ...
Loading ...