Loading ...
Loading ...
Loading ...
1010
FASTENING THE COOKTOP
Each cooktop is provided with an installation
kit including brackets and screws for
fastening the cooktop to benches from 30
to 40mm thick.
Model NSL 460 NCM, (g. 3a): The kit
includes two “F” type brackets (for the
front of the cooktop), two “R” type brackets
(for the rear of the cooktop) and four self-
threading screws “S”.
Model NSL 590D NCM (g. 3b): The kit
includes four “F” type brackets (for the front
of the cooktop), three “R” type brackets (for
the rear of the cooktop) and seven self-
threading screws “S”.
• Cut the unit according to the
dimensions in g. 2a.
• Stretch gasket “G” over the edge of
the hole made, being careful to overlay
the junction edges (fig. 3c).
• Fasten the brackets “F” and “R” to
the appropriate socket holes, without
tightening the screws “S” for the
moment. Make sure that the tabs are
mounted correctly, as shown (gs.
3d, 3e). Rotate the tabs so that the
cooktop can be put into the cutout.
• Put the cooktop into the cutout and
position it correctly.
• Put the brackets “F” and “R” into place;
tooth “A” of the brackets should go into
the hole (gs. 3d, 3e).
• Tighten screws “S” until the cooktop is
completely secured to the bench.
• Using a sharp cutter or trimmer knife,
trim the excess sealing material
around the edge of the cooktop.
Take care not to damage the
workbench.
F
F
F
F
R
R
R
F
F
R
R
F
F
F
F
R
R
R
F
F
R
R
G
G1
G2
Figure 3a
Figure 3b
Figure 3c
Loading ...
Loading ...
Loading ...