Loading ...
Loading ...
Loading ...
12
Outside Rear Exhaust – 3 ¼” x 10” Rectangular
Use the diagram to the right or the hood itself as a template and mark the locations on the cabinet
for ductwork and keyhole screw slots.
Recirculating
• Use the hood as a template and mark the locations on the cabinet for ductwork and keyhole
screw slots.
• Since the hood is to be recirculated (not to be vented outside), do not cut out any vent openings
in the wall or cabinet bottom.
Cut Holes
• Cut holes at marked locations for duct.
• For the vertical duct, cut out ¾” extra toward the front of the cabinet so you can move the duct
freely when installing the hood. It may also ease installation by cutting the hole 10 ½” instead of
10”.
•
Drive a mounting screw (from the hardware packet) part way into each center of the narrow
neck of the keyhole slots marked on the cabinet bottom.
Wood shims
(recessed-bottom cabinets only–shims must be
a minimum of 3/8
″ thick and cut to fit the width
of the inner recessed cabinet bottom)
Cabinet front
Center line
Hood mounting
screws (4)
Cabinet
bottom
1
⁄
4
″
4
1
⁄
4
″
5
1
⁄
4
″
5
1
⁄
4
″
Horizontal duct
access hole
10
7
⁄
8
″ (24″ hood)
16
7
⁄
8
″ (36″ hood)
13
7
⁄
8
″ (30″ hood)
10
7
⁄
8
″ (24″ hood)
16
7
⁄
8
″ (36″ hood)
13
7
⁄
8
″ (30″ hood)
Loading ...
Loading ...
Loading ...