Loading ...
Loading ...
Loading ...
2
TROUBLESHOOTING
You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM POSSIBLE CAUSE REMEDY
Appliance does not
operate
Appliance is not connected to a power
supply.
The appliance is turned off.
Tripped circuit breaker or a blown a fuse.
Connect the appliance.
Switch on the appliance.
Switch on the circuit breaker or replace fuse.
Appliance is not cold
enough
The temperature is not set correctly.
The ambient temperature could require a
lower temperature seing.
The door was not closed completely.
Door is not hermetically sealed.
The condenser is too dirty.
The ventilation opening is blocked or too
dusty.
Check the set temperature.
Set a lower temperature.
Do not open the door more oen than
necessary.
Close door properly.
Check the door seal and clean or replace.
Clean the condenser when necessary.
Clear the obstructions and clean the dust.
Appliance turns itself on
and off frequently
The room temperature is higher than
average.
The door is open too oen.
The door is not closed completely.
The door gasket does not seal properly.
Put the appliance in a cooler place.
Leave the appliance to work for a while until
the set temperature has been reached.
Do not open more than necessary.
Close door properly.
Check the door seal and clean/replace.
The light does not work Appliance is not connected to a power
supply.
Tripped circuit breaker or blown a fuse.
The light was switched off on the control
panel.
Connect the appliance.
Switch on circuit breaker or replace fuse.
Switch on the light.
Vibrations The appliance is not properly leveled. Level the appliance with the adjustable feet.
The appliance seems to
make too much noise
The raling may come from the flow of the
refrigerant, which is normal. As each cycle
ends, you may hear gurgling sounds caused
by the flow of refrigerant in your appliance.
If the temperature fluctuations occur, the
contraction and expansion of the inner walls
may cause popping and cracking noises.
The appliance is not properly level. Level the appliance with the adjustable feet.
The door will not close
properly
The appliance is not properly level.
The door was reversed and not properly
installed.
The gasket is dirty.
Level the appliance with the adjustable feet.
Check the door hinge and reassemble
correctly.
Clean the door gasket.
The alarm sounds and
the temperature display
flashes
Has the appliance door been open for
longer than 60 seconds? If not, then the
temperature has risen higher or fallen lower
than the temperature that has been set.
This could be due to:
The appliance door being opened too oen.
The ventilation opening being covered or
too dusty.
A lengthy interruption in the power supply.
If yes, close the door.
Do not open the door more oen than
necessary.
Clear the obstructions and clean the dust.
Leave the appliance to work for a while until
the set temperature has been reached.
Loading ...
Loading ...
Loading ...