Summerset SSRFR24D Grills Deluxe Series 24 Inch Counter Depth Compact Refrigerator

User Manual - Page 10

For SSRFR24D.

PDF File Manual, 14 pages, Read Online | Download pdf file

SSRFR24D photo
Loading ...
Loading ...
Loading ...
3
OPERATING YOUR APPLIANCE
It is recommended that you install the appliance
in a place where the ambient temperature
is between 50°F and 109.4°F (10°C-43°C). If
the ambient temperature is above or below
recommended temperatures, the performance
of the unit may be affected. For example, placing
your unit in extremely cold or hot conditions
may cause interior temperatures to fluctuate.
The operating temperature range may not be
reached.
Remove the exterior and interior packing.
Before connecting the appliance to the power
source, let it stand upright for approximately
24 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water
using a so cloth.
Install the handle on the door if not already
aached.
Your outdoor refrigerator has been designed
for both built-in and free standing applications.
When built-in, your refrigerator door does not
require additional air space for top, side or rear.
The front grille must not be obstructed.
1. Position the unit on a flat, level surface
capable of supporting the entire weight
of the unit. Remember the unit will be
significantly heavier once it is fully loaded.
2. Connect the unit to a Ground Fault
Interrupter (GFI).
3. The unit must be installed according to your
local codes and ordinances.
4. ELECTROCUTION HAZARD!
Electrical Grounding Required - This
appliance is equipped with a three
prong (grounding) polarized plug for
your protection against possible shock
hazards.
NEVER remove the round grounding
prong from the plug.
NEVER use a two prong grounding
adapter.
NEVER use an extension cord to connect
power to the unit.
Where a two-prong wall receptacle is
encountered or a longer power cord is
required, contact a qualified electrician
to have it replaced in accordance with
applicable electrical codes.
It is recommended that you do not install
the appliance near an oven, radiator or other
heating source, as heat sources may increase
electrical consumption. Do not install in a
location where the temperature will fall below
50°F (10°C). For best performance, do not
install the appliance behind a cabinet door or
block the base grille. Plug the appliance into
an exclusive properly grounded wall outlet.
Press first, then press or buon
to increase (warm) or decrease (cool) the set
temperature by 1°C/ 1°F.
Press again, the temperature is selected and
shows the actual temperature. If no other further
operation in 6 seconds, display will show actual
temperature in the cooler
The temperature you are seing will increase by
one degree each time you press the key and
will decrease by one degree each time you press
the key.
The range of temperature control is from 32°F
to 50°F.
To view the set temperature at any time, press
the key. The set temperature will flash in the
display window for 6 seconds. Aer 6 seconds,
the temperature inside the until will reappear in
the display window.
(The temperature preset at the factory is 36°F)
CONTROL PANEL
°F/°C SELECTOR
SETTING THE TEMPERATURE CONTROL
BEFORE USING YOUR APPLIANCE
INSTALLATION OF YOUR APPLIANCE
SITE PREPARATION
NOTE:
ON/OFF Power
To turn the appliance ON or OFF, press and hold
the POWER key for 5 seconds.
UP and DOWN
SET
SET
Selects the temperature display seing in
Fahrenheit or Celsius degrees. To change the
temperature from Fahrenheit to Celsius or from
Celsius to Fahrenheit, press and at the
same time, then hold for 6 seconds.
SET
SET
Loading ...
Loading ...
Loading ...