Loading ...
Loading ...
Loading ...
HOW TO SET UP YOUR SNOW
THROWER
Your snow thrower is equipped with height adjust
skids (See Fig. 2) on the outside of the auger
housing. To adjust the skid height, see To Adjust
Skid Height paragraph on page 18,.
TO INSTALL THE UPPER HANDLE AND
CRANK ASSEMBLY
On the right side of the handle, installand secure the
following parts (found in parts box) in the lower
handle hole as shown in Fig 4A:
1 - 3/8" x 2" bolt
2 - 3/8" flatwashers
t - 3/8" lockwasher
t - 3/8" nut
® Remove the 318" nylon locknut and flatwasher from
the eye bolt assembly (on the chute crank assembly).
Check to make sure the two 3/8" jam nuts are tight,
The jam nuts should be 275 inches from the end of
the eye bolt (Fig. 4B inset)
e Install eye bolt through lower hole on the left hand
side of the handle (See Fig. 4B).
• Install the 3/8" flatwasher and the 3/8" nylon locknut
loosely on the eye bolt as shown in Fig 4B
e Remove the plastic bag from chute crank assembly
Remove the plastic cap, cotter pin and washer from
the wormed end of the auger assembly (see Fig 5),
® Rotate the notched section of the discharge chute
toward the crank-adjusting rod (See Fig 5).
e install the wormed end of the crank fhrough the hole
in the adjusting rod and secure the end with the flat
washer and cotter pin, as shown in Fig 5
• Bend the ends of the cotter pin around the rod and
reinstall the plastic cap,,
e Tighten the eye bolt installed earlier, keeping eye in
line with the rod while tightening the inside securely
• Rotate the chute crank fully clockwise and fully
counter-clockwise. The discharge chute should
rotate fully to the outer diameter of the worm and
should clear approximately 1/8" (See Fig. 5).. If the
chute crank needs to be adjusted, go to the
Service and Adjustments section on page 18 Screws
securing chute clips at the base of the chute should
be slightly loose for easy rotation,.
NOTE: Be sure the crank does not touch the side of the
engine or the cover will be scratched,
BRACKET
3mlN, BOLT
INNERMOST NUT
NUT 3,"8 FLAT'WASHER
LOCKWASHER
FIG. 4A
ADJUST NUTS TO MOVE
EYE :BOLT IN OR OUT
CRANK
EYE BOLT
NYLON
3_/8 LOCKNUT
FLATWASHER
3/8 _ FLA"P#ASHER
JAM NUTS
2. 75 IN_
I END OF
EYE BOLT
FIG. 4B inset
i[ iL ,,,,,,,,,,,
FIG. 4B
"_" NOTCHED SECTION
PLASTIC % ,.
CAP COTTER
PIN /8 INCHCLEABANC
O
FLA
| _ _k\,, J//_".,,_ 1/2 INCH
8
FIG, 5
Loading ...
Loading ...
Loading ...