Loading ...
Loading ...
Loading ...
TheLCDDispayscreenflickers, Displayissecurelyconnected.
(RefertoConnectingtoaComputer)
: P_oberosire#arealtoH'_eScreen
[] Note
. ProblemsrelatedtotheLCDDisplayscreenandtheirsolutionsarelisted
Problems
Thescreenisblankandthepower
indcators off,
'CheckSigna_CabBe"message,
_NotOptmumMode_message
Thepctureroilsvertically,
Theimageisnotdear;pictures
b_urred,
ThepctureimageisunstabBeand
shakes,
Ghostimagesareshowninthe
picture,
Theimages toolightortoodark,
Thescreencootisinconsistent,
Thecootimages distortedby
darkshadows,
Thecootwhteispoor,
ThepowerIndicatorblinksgreen
Thescreenisblankandthepower
indicator_ightissteadygreenor
blinksevery05orI seconds,
Thescreenisblankandits
blinking,
o
o
o
Solutions
Ensure that the power cord is firmly connected and the LCD
LCD Display is on.
(Refer to the Connecting the LCD Display )
Ensure that the signal cable is firmly connected to the PC or
video sources
(Refer to the Connecting the LCD Display )
Ensure that the PC or video sources are turned on.
Check the maximum resolution and the frequency of the video
Adaptor.
Compare these values with the data in the Preset Timing Modes
Chart.
Check if the signal cable is securely connected.
Re-connect it, if necessary.
(Refer to Connecting to a Computer)
® Run Frequency Coarse and Fine tuning.
Turn on again after removing all accessories
(video extension cable, etc)
® Set the resolution and frequency to the recommended ranges.
Check if the resolution and frequency set for the computer video
card fails in the range supported by the LCD Display
If not, reset them referring to the current information under the
LCD Display menu and Preset Timing Modes
® Adjusts the brightness and contrast.
(Refer to the Brightness. Contrast)
® Adjust color using Custom under OSD Color Adjustment menu
The LCD Display is currently saving the changes made to the
settings to the OSD memory
® The LCD Display is using its power management system.
Press a key on the keyboard
If you see the "TEST GOOD" message on the screen when you
pressing the MENU button, check the cable connection between
the LCD Display and the computer to ensure that the connector
is properly connected
> P_ob eros ire ated to Audo
[] Note
Loading ...
Loading ...
Loading ...