Loading ...
Loading ...
Loading ...
29
HOW TO MAINTAIN THE EXERCISE BIKE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the exercise bike is used.
Replace any worn parts immediately. Use only
manufacturer-supplied parts.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
PEDAL MAINTENANCE
Tighten the pedals weekly. Tighten the right
pedal clockwise, and tighten the left pedal
counterclockwise.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If you are having problems connecting the console
to a wireless network or if you are having problems
with your iFIT account or iFIT workouts, go to
support.iFIT.com.
If the console does not boot
up properly, or if the con-
sole freezes and does not
respond, reset the console
to the factory default set-
tings. IMPORTANT: Doing
this will erase all custom settings you have made
to the console. Resetting the console requires two
people. First, unplug the power adapter. Next, locate
the small reset opening (A) on the side or back of the
console. Using a bent paper clip, press and hold the
reset button inside the opening, and have a second
person plug in the power adapter. Continue holding the
reset button until the console turns on. When the reset
operation is complete, the console will turn off and then
turn back on. If it does not, unplug the power adapter
and plug it in again. Once the console turns on,
check for fi rmware updates (see HOW TO CHANGE
CONSOLE SETTINGS on page 26). Note: It may
take a few minutes for the console to be ready for use.
HOW TO ADJUST THE REED SWITCH
If the console does not display accurate feedback, the
reed switch should be adjusted. Before you adjust the
reed switch, unplug the power adapter.
Next, insert a standard screwdriver under the left
Shield Disc (18) in the location shown by the arrow,
and gently pry the Shield Disc off the Left Shield (11).
Then, carefully move the Shield Disc over the Left
Crank Arm (63) and away from the opening in the Left
Shield.
See the inset drawing above. Locate the Reed
Switch (35). Turn the Left Crank Arm (63) until a
Magnet (55) is aligned with the Reed Switch. Next,
loosen the M5 x 16mm Screw (76), slide the Reed
Switch slightly closer to or away from the Magnet, and
then retighten the Screw.
Then, plug in the power adapter, and move the Left
Crank Arm (63) back and forth so that the Magnet (55)
passes the Reed Switch (35) repeatedly.
Repeat these actions until the console displays correct
feedback. Then, reattach the left shield disc.
A
35
76
63
18
11
63
55
MAINTENANCE AND TROUBLESHOOTING
Loading ...
Loading ...
Loading ...