Loading ...
Loading ...
Loading ...
12
FINAL INSTALLATION
If you wish to use the fan WITH the light kit,
remove finial (O), finial plate (I), rubber washer (Q)
and hex nut (K) from the threaded rod at the bottom
of the light kit fitter (F). Save hardware for later use.
5.
5
Threaded
Rod
O
I
Q
F
K
NOTE: To install the fan without the light kit, proceed to INSTALLING FAN WITHOUT LIGHT KIT on
page 14.
Insert the end of one blade arm (S) into the
keyhole slot on the motor housing (D). Twist blade
arm (S) clockwise to lock in place.
Repeat with remaining blade arms (S).
3.
J
S
D
Keyhole
Slot
3
Should it become necessary to remove blade arm (S)
from motor housing (D), follow these steps:
Remove blade arm screws (T) and washers (U) from
underside of motor housing (D) and remove blade arm
assembly. Remove safety screw (V) and metal tab (W)
from blade arm wall. Twist blade arm (S)
counterclockwise to remove from blade arm wall.
To reinstall blade arm (S), reattach metal tab (W) to
blade arm wall with safety screw (V). Reattach blade
arm wall to motor housing (D) with blade arm screws
(T) and washers (U). Refer to step 3 to reinsert blade
arm (S).
4.
4
D
S
S
T
U
W
V
Loading ...
Loading ...
Loading ...