Loading ...
Loading ...
Loading ...
8
BASE FEET
PRESSURE GAS REGULATOR INSTALLATION INSTRUCTION
Pressure gas regulator is supplied with the appliance. It is stored in the oven.
A
B
D
C
Legs are packed in carton box. Legs should be installed near to where the appliance is to be used, as they are
not secure for long transit. After unpacking the range, raise it about a foot to remove the bottom shipping skid.
Keep the unit raised to allow legs to be screwed into their couplings and lower it gently to keep any undue strain
from the legs and internal mounting hardware. It is strongly recommended that a pallet or lift jack be used rather
than tilting.
MAJESTIC
Fig. 1a
1) Remove the foot (A) from the cooker
and x in the foot cover (D)
2) Secure the foot cover (D) with three bol-
ts, the three washers and the three nuts (B)
into the bracket (C) which is positioned at
the rear of the kitchen
MAJESTIC LION PAW FEET
Fig. 1b
1) Insert the bolt (A) into the bracket
hole and tighten the nut (B).
2) Insert the pin between the bra-
cket and the xing support (D) and
tighten the nut (B).
PROFESSIONAL
Fig 1c
1) Screw partially bolt (F) into
the base foot (G).
2) Insert base foot (G) into the
hole (Ha), move in to the slot
(Hb) and screw completely
bolt (F).
B C
A
A A CB BC
B
D
B
Fig. 2a
As show in Figure 2a, unscrew B part from C part.
Screw C part into A part (Fig. 2a). Please use a proper gasket, for this connection.
As show in Figure 2b, screw A+C part into part B.
Fig. 2b
Loading ...
Loading ...
Loading ...