Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Won't Drain/ Lowvoltageor using Check electrical source or call
Won't Spin/ anextension cord. electrician, Do not use extension
Wet Loads cords.
(cont.) Cold rinses. Cold rinses leave loadswetterthan
warm rinses.Thisis normal
Continues Drainhoseislessthan Raisethe drainhose (see
tOFiW 39 in (99 cm) above floor. "_nstallationInstructions").
Continues
to Drain/ Drain hose fits tightly into Adjust drainhose for loosetit
Cycle Stuck standpipe. (see"Installation instructions")
Drain hose taped into Do not seal off drain hose with tape.
standpipe. The drain hose needs an air gap
Washer Makes Load is unbalanced. Redistribute load,
Noise
Washer is not level Level washer. Reset rear legs
Rear leveling legsnot set (see 'Installation Instructions").
Nuts on front feet net tight. Tightennuts (see "Installation
Instructions").
Yellowshipping strap with Remove strap withcotter pins
cotter pins notcompletely (see"Installation Instructions").
removed.
Floornot strong enough Relocate washer (see"Installation
to support washer, Instructions").
Gears engaging after drain This is normal
and before spin,
Upper part of agitator cticks This is normal.
during wash.
Won't Waterinlet valve Clean screens.
RII/Won't screens are plugged.
Rinse/Won't
Agitate/ Wateristurnedoft. Turnon water.
Wrong Hot and coldhosesare Reversehoses(see "Installation
Temperature reversed. Instructions').
Inlethose iskinked. Straighten hoses.
Timer dial is notlined up. Turn timer knob to the right slightly
and pullto start.
Powercord not plugged in, Plug into agrounded 3 prong outlet,
28
Loading ...
Loading ...
Loading ...