Loading ...
Loading ...
Loading ...
Thecorrectreplacementbarandchain
isaisospecifiedonadecaIlocatedon
thechainsaw.
SeeyourSearsServiceCentertore-
placeandsharpenindividualcutters
onyourchain.
TOREPLACECHAIN:
1. MoveON/STOPswitchtotheSTOP
position.
2. Loosenandremovebarknobcom-
pletelybyliftingteverandturning
counterclockwise.
_OOSEN
3. Loosen chain tension by turning
adjusting wheel (upward direction).
Remove ctutch cover.
,\,
Clutch Cover
\
Ear
Knob
4. Stide guide bar on bar boIts until
guide bar stops against clutch
drum sprocket.
Guide bar
Bar bolts _
5. Remove the otd chain.
6. Carefully remove the chain from the
package. Hold chain with the drive
links as shown.
DHRECTION OF ROTATION
Cutters Depth Gauge
Drive Links
7. Place chain over and behind clutch
retainer, fitting the drive links in the
clutch drum sprocket.
8. Fit bottom of drive tinks between
the teeth in the sprocket in the
nose of the guide bar.
9. Fit chain drive tinks into bar groove.
10. Pult guide bar forward until chain is
snug in guide bar groove. Ensure
all drive links are in the bar groove.
11. Install clutch cover. Be sure adjust-
ing pin is in the adjusting pin hole
in the guide bar.
CAUTION: tt is very important when
instaIling the clutch cover that the adjust-
ing pin aligns into the adjusting pin hole
in the bar. Failure to instalt the clutch
cover correctly may result in permanent
damage to your chain saw.
B ok
view of
clutch
vet
Adjusting pin
12. Install bar knob and finger tighten
only. Do not tighten any further at
this point. Proceed to CHAIN AD-
JUSTMENT.
CHAIN ADJUSTMENT
See CHAIN TENSION in MAINTENANCE
section.
CARBURETOR ADJUSTMENT
'_' WARNING: The chain wiil be
moving during most of this procedure.
Wear your protective equipment and
observe all safety precautions. The
chain must not move at idie speed.
19
Loading ...
Loading ...
Loading ...