Loading ...
Loading ...
Loading ...
The operation of any lawn
SAFETYGLASSESmower can result in foreign
objects thrown into the eyes,
which can result in severe eye
damage. Always wear safety
glasses or eye shields while operating your
lawn mower or performing any adjustments
or repairs. We recommend a standard safety
glasses or wide vision safety mask worn
over spectacles.
HOW TO USE YOUR MOWER
THROTTLE / ENGINE CONTROL
The engine is controlled by a throttle control
located on the side of the upper handle.
CHOKE position isfor starting acold engine;
FAST position is for starting a warm engine,
normal cutting, trimming and better grass
bagging; SLOW position is for light cutting,
trimming and fuel economy, and STOP posi-
tion is for stopping the engine.
I\1 FAsTslow
•" " - STOP
CHOKE t ", "-
11/ lj # I '"
/ "_..,.. ,.,, ,,.- ,
/ f ,',,; ',
XIt/A ,I _, _.Z-
II \l '"
BLADE CONTROL
,ACAUTION: When the blade control is
engaged, the blade turns.
• To start the blade, push the blade/brake
control lever forward (1) and hold the op-
erator presence control bar down to the
handle (2). To stop the blade, release the
operator presence control bar.
Allow a cold engine to warm up in high idle
position for one minute before engaging
the blade.
NOTE: It is normal to hear the belt slip as the
blade is engaged and comes up to speed.
• Do not start the blade in uncut grass.
Move the mower out of uncut grass
before starting the blade.
,_CAUTION: Federal regulations require
this blade/brake control to minimize the
risk of blade contact injury. Do not under
any circumstances attempt to defeat the
function of this control.
'\\\
\
\\
\\\\\
\\\
\\
Blade/brake
control lever
Operator
presence
control bar
i
\ \
\ \
\
\\
\\
\\\
\\\
\\
\
\
TO ENGAGE BLADE
DRIVE CONTROL
• Self-propelling is controlled by holding
the operator presence control bar down
to the handle and pulling either drive
control lever rearward to the handle.
The further toward the handle a lever is
pulled, the faster the unit will travel.
• Forward motion will stop when either
the operator presence control bar or a
drive control lever are released. To stop
forward motion without stopping engine,
release a drive control lever only. Hold
operator presence control bar down
against handle to continue mowing
without self-propelling.
NOTE: If after releasing the drive control
the mower will not roll backwards, push
the mower forward slightly to disengage
drive wheels.
Operator presence control bar
8
rive
control levers
TO ENGAGE
DRIVE CONTROL
DRIVE CONTROL
DISENGAGED
DRIVE CONTROL ADJUSTMENT
Over time, the drive control system may
become "loose", resulting in decreased
speed. There is a turnbuckle on the drive
control housing to increase tension on the
drive cable. Proceed as follows:
1. Turn unit off and disconnect spark plug
wire from spark plug.
Loading ...
Loading ...
Loading ...