Loading ...
Loading ...
Loading ...
IMPORTANT: Always ensure that the venturi burner tubes are
clean. A venturi burner tube has a narrow area in which
spiders tend to build nests.
If you notice that your grill is getting hard to light or that the
flame isn't as strong as it should be, take the time to check
and clean the venturi's
Spiders or small insects have been known to create
"flashback" problems. The spiders spin webs, build nestsand
lay eggs in the grill's venturi tube(s) obstructing the flow of
gas to the burner. The backed-up gas can ignite in the venturi
behind the control panel Thisis known as a flashback and it
can damage your grill and even cause injury
To prevent flashbacks and ensure good performance the
burner and venturi assembly should be removed from the grill
and cleaned before use whenever the grill has been idle for
an extended period
Storing Your Grill
Cleaning the Burner Assembly
Follow these instructionsto clean and/or replace parts of burner
assembly or if you have trouble igniting grill
1 Turn gas off at control knobs and LPcylinder.
2. Remove cooking grates and heat diffusers
3. Remove screws and nuts from rear of burners
4 Remove screw and nutfrom igniter pin and put igniter pin on
the side.
5. Carefully lift each burner up and away from gas valve orifice.
We suggest three ways to clean the burner tubes. Usethe one
easiest for you.
(A) Bend a stiff wire (a light weight coat hanger works well)
into a small hook. Runthe hook through each burner tube
several times
(B) Usea narrow bottle brush with a flexible handle (do not
use a brass wire brush), run the brushthrough each burner
tube several times.
(C) Wear eye protection: Use an air hose to force air into the
burner tube and out the burner ports Check each port to
make sure air comes out each hole.
6. Wire brush entire outer surface of burner to remove food
residue and dirt
7. Clean any blocked ports with a stiff wire such as an open
paper clip.
8. Check burner for damage, due to normal wear and corrosion
some holes may become enlarged. If any large cracks or holes
are found replace burner.
VERY IMPORTANT: Burner tubes must reengage
gas valve orifice. See illustrations below.
9 Carefully replace burners
10.Attach burners to brackets with screws and nuts as shown below.
11 Repositionigniter pinsand attach to burners Replace heat
diffusersand cooking grates.
_' Clean cooking grates.
" Store in dry location.
" When LPcylinder is connected to grill, store outdoors in a
well-ventilated space and out of reach of children
Cover grill if stored outdoors Choose from a variety of grill
covers offered by manufacturer once available.
" Store grill indoors ONLY if LPcylinder is turned off and
disconnected, remove from grill and stored outdoors.
" When removing grill from storage, follow "Cleaning the Burner
Assembly" instructions before starting grill.
REV 2
23671=46477279 - 9
Loading ...
Loading ...
Loading ...