Loading ...
Loading ...
Loading ...
EMERGENCIES: Jf a gas leak cannot be stopped, or a fire occurs due to gas Jeakage_ call the fire department.
Gas leaking from
cracked/cut/burned
hose.
" Damaged hose.
*Turn off gas at LPcylinder or at source on natural gas systems. If the hose
s cracked or cut but not burned, simply replace valve / hose / regulator.
Jfthe hose is burned,the cause could be other than a faulty valve/hose/
regulator. Discontinueuse of grill until a plumber or gas technic an has
nvestgated and corrected the problem_
GasbakingfromLP " Mechanicalfailuredueto rustingor • ReplaceLPcylinder.
cylinder, mishandling.
GasleakingfromLP • Failureof cylindervalvefrommishandling • TurnoffLPcylindervalve.ReturnLPcylinderto gassupplier.
cylindervalve, or mechanicalfailure.
Gasbaking betweenLP " improperinstallation,connectionnot • Turnoff LPcylindervalve.Removeregulatorfromcylinderandv suaJJy
cylinderandregulator tight,failureof rubberseal, inspectrubbersealfor damage.SeeLPCylinderLeakTestandConnecting
connection. Regulator to the LPCylinder.
Firecomingthrough " Firein burnertubesectionof burner *Turnoff controlknobsandLPcylindervalve.Leavelid opento allowflames
contrd panel, dueto blockage, to diedown.Afterfire isoutandgrill iscold,removeburnerandinspect
forspidernestsor rust.SeeSpiderAlertandCleaningtheBurnerAssembly
sectionsof thisUse& CareGuide.
excessiveflamesabove to die down.Aftercoding, dean food particles andexcessgreasefrom
cookingsurface, insidefireboxarea,greasetray,andothersurfaces.
Troubleshooting
Burner(s) will not light
using igniter. (See
Electronic ignition
Troubleshooting also)
• See instructions on control panel and in Use and Care section.
Make sure valves are positioned inside of burner tubes.
" Trying to light wrong burner.
• Burner not engaged with control
valve.
• Obstruction in burner.
Wires are shorting (sparking)
between igniter and electrode.
Ensureburner tubes are not obstructed with spider webs or
other matter. See cleaning section of Useand Care.
No gas flow. • Make sure LPcylinder is not empty. If LPcylinder is not empty,
refer to "Sudden drop in gas flow."
• Vapor lock at coupling nut to LP • Turn off knobs and disconnect coupling nut from LPcylinder.
cylinder. Reconnect and retry.
• Coupling nut and LPcylinder valve not • Turn the coupling nut approximately one-half to three-quarters
fully connected, additional turn until solid stop. Tighten by hand only - do not use
tools,
• Electrode cracked or broken; "sparks • Replace electrode(s).
at crack.
• Electrode tip not n proper position. Main Burners:
° Tip of electrode should be pointing toward gas port opening
on burner. The distance should be 1/8" to 1/4'. Adjust if
necessary.
cooking residue, swab,
• Wires are loose or disconnected. • Reconnect wires or replace electrode/wire assembly.
• Replace igniter wire/electrode assembly.
• Dead battery. • Replace with a new AAA-size alkaline battery.
REV 2 23671-46477279.27
Loading ...
Loading ...
Loading ...