Loading ...
Loading ...
Loading ...
Automatic Ice and
Water Dispenser
(continued)
Do not use icechute
as a handle when removing or
replacing ice storage bin. Surfaces
there may be sharp.
DO NOT PUT FINGERS UP ICE CHUTE,
SURFACES THERE MAY BE SHARR
Ice Dispenser Tips
1. Ice cubes stored too long may develop an odd flavor. Empty the container
and return it to the proper position. Ice maker will then produce more ice.
2. Occasionally shake container to keep iceseparated.
3. If dispensing arm ispushed in for more than 4 minutes, the dispenser motor may
overload and stop. The overload protector will reset automatically after 3 or 4
minutes. If a large quantity of ice isneeded at one time, it isbest to remove cubes
directly from ice storage bin.
4. Certain sounds are normal when the ice maker isoperating. They are:
• Motor operation
• Ice being loosened from the tray
• Icedropping into the storage bin
• Running water
• Water valve opening or closing
Formore information on these operations, seeNormal Operating Soundssection.
5. Stop the ice maker when cleaning the freezer, or for long vacations.
6. If the ice maker isto be turned off for a long period of time, turn water supply
valve to the closed position.
Cleaning Ice Dispenser
Clean the dispenser and icestorage bin at regular intervals,particularly before you
take a vacation, move, or if icedispenser sticks
1. Stop ice production by lifting the wire signal arm to the "up" or OFFposition.
2. Remove icestorage bin by lifting up and out. Empty and carefully clean bin with
mild detergent. Do not submerge auger while cleaning. Rinsewith clear water.
Do not use harsh or abrasive cleaners. Allow ice bin to dry completely before
replacing in the freezer.
3. Remove icechips, and clean the shelf and chute that supports the icestorage
bin.
4. Replace ice storage bin. Lower the wire signal arm on the ice maker to the
"down" or ON position. Ice maker will resume production.
IMPORTANT: When removing or replacing ice bin, do not rotate the auger in the
ice bin. If auger isaccidentally turned, you must realign the auger by turning it in
90 ° turns, until the ice bin fits into place with the drive mechanism. For further
instruction, see label on ice bucket.
Remove and empty the ice storage bin if:
1. Anextended power failure (one hour or longer) causesicecubes in the icestorage
bin to melt, freeze together, and jam the dispenser mechanism.
2. Theice dispenser isnot usedfrequently. Icecubeswill freeze together inthe bin
and jam dispenser mechanism. Remove ice storage bin, and shake to loosen
cubes.
DRVFR f
MFCqA SM
Repositioning the Auger
NEVER usean icepick or similar sharp instrument to break up ice.Thiscould damage
the icestorage bin and dispenser mechanism.
PureSourcePlus TM Ice and Water Filter (some models)
NOTE: If you purchased a refrigerator with a PureSource PlusTMIce and
Water filter, please read the following use and care information.
This iceand water filter systemfilters water to your ice maker and water dispenser.
It islocated inthe upper right back corner of the fresh food compartment (seeFigure
1 on the following page).
System Startup:
Water supply does not need to be turned off, however do not use ice and water
dispenser while installing filter. Referto Figure1 asyou completethese instructions.
Thefilter cartridge hasalready been installed inthe filter housing atthe factory. Refer
to the How the Dispenser Works section to properly fill the system with water.
Loading ...
Loading ...
Loading ...