Loading ...
Loading ...
Loading ...
Automatic Ice and
Water Dispenser (continued)
Order new filter cartridges through the
dealer where you bought the
refrigerator, or contact the Frigidaire
Consumer Assistance Center at 1-800-
944-9044. It might be good to order
some filters when you first install your
refrigerator. Be sure to ask for the RC-
200 PureSource Plus TM replacement
cartridge.
The PureSource Plus TM RF-200 ice and
water filter system is tested and certified
by NSF International, the nationally
recognized and respected, not for profit,
certification organization for public
health safety. The PureSource Plus TM
system is tested and certified to ANSI/
NSF Standards 42 and 53. See
performance data sheet for specific
claims. This system should not be used on
water that is microbiologically unsafe or
with water of unknown quality unless
the water has been adequately
disinfected before or after traveling
through the filtration system.
Rated service flow- .37 GPM
Maximum Rated Pressure- 125 PSI
Maximum Operating Temp. - 100 °
Changing the Filter:
Water quality varies throughout the world. To ensure the highest possible water
quality, change water filter every 6 months, or 200 gallons. Also, if filter has been
in a refrigerator that has not been in use for awhile (during moving for example),
change filter before reinstalling refrigerator. Notedispenser system will alsooperate
without filtration (with filter cartridge removed).
To change filter:
Referto Figure 1 asneeded. It isnot necessaryto turn the water supply off to change
the filter.
1. Set ice maker lever (wire signal arm) to the OFF(up) position.
2. Hold filter cup firmly, and unscrew counter clockwise (Figure 1). (Some water
could leak out asyou remove cup. This isnormal.) Filter cartridge should come
down with cup. Ifcartridge remains in housing, pull down gently, while twisting
filter back and forth.
3. Empty cup of any substance.
4. The large o-ring (Figure 1) that sealsthe filter system sets in the o-ring groove
down inside the cup. Should the o-ring fall out during filter cartridge replacement,
simply place it back in the groove prior to screwing the cup back in place. If the
o-ring becomes damaged, you will need to order a new one from the Consumer
Assistance Center.
5. Discard old filter cartridge.
6. Remove new filter cartridge from packaging, and install.
7. Placefilter cartridge in cup. The end with the small o-ring should be up, out
of the cup.
8. Screw cup, with filter, back onto housing. Do Not Use Wrench To Reinstall
Cup. Filter cartridge will self-align ascup istightened. Besure cup iscompletely
tightened with Pure$ource Plus TMLogo facing outward. Do Not Tighten Past
Stop.
9. Set ice maker level on the ON (down) position.
10.Check for leaks.Open refrigerator door. Wipe anywater drops from the filter cup.
Run a glass of water. If there isa leak, unscrew filter cup, and reinsert the filter
cartridge. Check placement of large O-ring (seeFigure1). Reinstall filter cup,
making certain it istightened completely.
11.Tocondition filter system and purge air from water line, run several glassesof
water through water dispenser. This will also assure that the purest water
possible isstored in water tank.
IMPORTANT
After replacing the filter cartridge, it will be necessary to reset the filter use up
indicator that islocated on the iceand water dispenser. Pressthe "Change Water
Filter" pad. If the indicator light was red or amber, you will need to pressthe pad
for 3-5 seconds to reset. Ifthe light isstill green you will need to pressthe padfor
10-12 seconds to reset. The light will flash on and off when reset iscomplete.
Pleaserefer to the complete dispenser operating instructions attached to the
inside of the freezer door.
Figure 1
10
Small O-tin
Cartridge
Large O-r eg_
Filter Cu pd_'_i i
TWIST TO REMOVE
Loading ...
Loading ...
Loading ...