Loading ...
Loading ...
Loading ...
Page 21
GAS INSTALLATION – Propane Tank Connection
LP Tank Connection
1. The tank valve should be in the“OFF”
position. If not, turn the knob clockwise until it
stops.
2. Make sure all burner valves are in the “OFF”
position.
3. Always connect the gas supply regulator as
follows: Insert the regulator inlet into the tank
valve and turn the coupling nut clockwise until
the coupler tightens up (see picture). Do not
over tighten the coupler. Turn the main tank
valve on and turn the burner control valves on
the unit to the “HIGH” position for about 20
seconds to allow the air in the system to purge
before attempting to light the burners.
LP Tank Disconnection
1. Turn the burner valves off.
2. Turn the tank valve off. (Turn
clockwise to stop).
3. Detach the regulator assembly
from the tank valve by turning
them quick coupling nut
Counterclockwise.
Hose and Regulator
The Type 1 connection system has the following features:
The system will not allow gas to flow until a positive connection has been made.
NOTE: The cylinder control valve must be turned off before any connection is made or removed.
The system has a thermal element that will shut off the flow of gas in the event of a fire.
The system has a flow limiting device which, when activated, will limit the flow of gas to 10 cubic
feet per hour.
NEVER use grill without leak testing.
LP (Propane) Gas Supply
Connection & Disconnection
Propane vapors are heavier than air. For this reason, they may accumulate in low-lying areas such as
basements, crawl spaces, and ditches, or along floors. However, air currents can sometimes carry
propane vapors elsewhere within a building
Loading ...
Loading ...
Loading ...