Loading ...
Loading ...
Loading ...
ADJUSTINGTHEOR
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Your door is aligned at the factory before shipment. OccasionaU re=adjustment may
be necessary, especially if an overlay paneU is installed. The following procedure
will correct for up to 1/4" alignment.
The door shouUd never be flush with the top of the cabinet. Even when ReveU,the top
edge of the door will be 1/8" below the top of the cabinet (see Figure 14).
,_1/8"
t
Figure 14
Toadjust :
1 Compare the top edge of the door (opposite the
hinges) to the top edge of the cabinet and note the
type (up or down) of adjustment needed.
2 Remove the top hinge pivot pin with a 7/64" hex
wrench (see Figure 15) and lift door off bottom
hinge pin. Be careful not to lose door closers (see
Figure 17).
3 With door upside-down, loosen but do not remove
the two hinge plate screws.
Figure 15
f
Loading ...
Loading ...
Loading ...