Admiral Craft BDCF12CG Diamond Series Freezer

Instruction Manual - Page 6

For BDCF12CG. Series: Diamond Series

PDF File Manual, 8 pages, Read Online | Download pdf file

BDCF12CG photo
Loading ...
Loading ...
Loading ...
JULY 2018
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE
Freezer does not operate. Not plugged in.
The circuit breaker tripped or blown fuse.
The freezer temperature control is set at “0”.
Compressor turns on and off frequently. The room temperature is hotter than normal.
A large amount of food has been added to the freezer.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The freezer does not have the correct clearances.
The freezer has recently been disconnected for a period of time.
Four hours are required for the freezer to cool down completely.
Temperature inside the freezer is too warm. Temperature control is set too warm. Turn the control to a cooler
setting and allow several hours for the temperature to stabilize.
Door is kept open too long or is opened too frequently.
Warm air enters the freezer every time the door is opened.
Open the door less often.
The door is not closed completely.
The door gasket does not seal properly.
A large amount of warm or hot food might have been stored
recently. Wait until the freezer has had a chance to reach its
selected temperature.
The freezer has recently been disconnected for a period of time.
Four hours are required for the freezer to cool down completely
Temperature inside the freezer is too cold. Temperature control is set too cold. Turn the control to a warmer
setting and allow several hours for the temperature to stabilize.
switch on the “7”, This causes continuous running of the
compressor and bypasses the temperature control.
Temperature of external freezer surface is warm. The exterior freezer walls can be as much as 30°F warmer than
room temperature. This is normal while the compressor works to
transfer heat from inside the freezer cabinet.
Popping or cracking sound when compressor
comes on.
Metal parts undergo expansion and contraction, as in hot water
pipes. This is normal. Sound will level off or disappear as freezer
continues to run.
Bubbling or gurgling sound, like water boiling. Refrigerant (used to cool freezer) is circulating throughout the
system. This is normal.
Vibrations. Check to assure that the freezer is not on a level surface.
Floor is uneven or weak. Freezer rocks on the oor when
it is moved slightly. Be sure oor can adequately support freezer.
Level the freezer by putting wood or metal shims under part
of the freezer. The freezer is touching the wall. Re-level the
freezer and move it from the wall. See “Installation Instructions”
Loading ...
Loading ...