Loading ...
Loading ...
Loading ...
Three-wire connection...
Three-wire receptacle
Where local codes Do Not permit
connecting cabinet-ground conductor to neutral wire:
4. Remove center terminal block
screw.
9. After realtaching the terminal
cover, connect a separate copper
ground wire from the external
ground connector screw to an
adequate ground.
5. Remove the appliance harness
ground wire (green with yellow \
stripes) from the external ground
connector screw. Connect
appliance harness ground wire and
the neutral wire (white or center) of
the power supply cord/cable under
the center, silver-colored terminal
block screw. Tighten screw.
=
terminal block screws. Tighten
screws.
7. Tighten strain relief screws. _ " "_
8.
Inserttab of terminal block cover
into slot of dryer rear panel. Secure
cover with hold-down screw.
mTo exhaust dryer, see Exhaust
requirements, Pages 3-4, Connect
exhaust vent to dryer exhaust outlet
and exhaust hood using 4" (10,2 cm)
clamps, Use caulking to seal exterior
wall opening around exhaust hood,
mCarefully move dryer into final
position, Place level on top of the
dryer, first side to side; then front to
back, If the dryer is not level, adjust
the legs of the dryer up or down until
the dryer is level,
1U • In U,S,or Canada, plug
power supply cord into grounded
outlet, Or, in the U,S,only, connect
direct wire to power supply,
Turn power supply on,
1 • Check dryer operation (some
accumulated time may be on the
timer due to factory testing),
Insert coins in slide and press slide in
slowly, (Operating time will
accumulate per number of coins and
Iype of timing cam used,) Push
START/RESTARTbulffon, Using a full
heat cycle (not the air cycle), let the
dryer run for at least five minutes,
Dryer will stop when time isused up,
Note: Dryer door must be closed for
dryer to operate, When door is open,
dryer stops, but timer continues to run,
To restart dryer, close door and push
START/RESTARTbulffon,
2 • If drying time is too long,
make sure lint screen is clean,
3m Now start the dryer and allow
it to complete a full heat cycle (not
air cycle) to make sure it isworking
properly,
Page 11
Loading ...
Loading ...
Loading ...