Loading ...
Loading ...
Loading ...
_l_ WARN|NG: 7-1/4 in. b|adeisthemaximumblade
capacityof thesaw.Also, neverusea blade that is
toothick to aliow outer bladewasherto engagewith
theflat onthe spindle. Largerbladeswiltcomein
contactwith the blade guards,whilethicker btadss
will preventblade screwfrom securingblade on
spindle. Eitherof thesesituations could resultin a
seriousaccident.
CAUTION: Toprevent damageto the spindle
or spindlelock, alwaysallowmotor to come to a
completestop beforeengagingspindlelock.
ATTACHING BLADE
See Rgures2 - 3.
= Unplugthe saw.
n Depressspindle lock button.
= Removeb[adescrew byturning itcounterolockwise
withthe wrench,while keepingthe spindlelock button
depressed,
m Removespringwasherand outarblade washer
("D"washer).
I=!Wipea drop of oil ontotheinnerflangebushingand
outerbladewasher("D"washer)wherethey contact
blade.
,_ WARN|NG: If innerflangebushinghasbeen
removed,replaceitbeforeplacingblade on spindle.
Failureto do so will preventblade from tightening
properlyand could resultIn seriouspersonalinjury.
BLADEGUARD
N_DLE OUIERWASHER
BUSHING / - /" BLADE
BLADE WASHER
Fig. 2
I Re&act the Zowerblade guard into the upper blade
guard using the lower blade guard hand(e_ Make sure
the tower guard spring works properly, allowing the
guard to move free_y,
m Check to see that the saw teeth and arrow on the saw
blade and the arrow on the lower guam are pot_ng tn
the same direction.
NOTE; The saw teeth point upward at the front of the
saw as shown.
m ;=Itthe saw blade Inside the lower blade guard and
onto the spindle,
E Replace =D" washer.
= Replace spring washer with cupped side against
"O" washer.
= Depress spindle lock button and replace blade SCraw,r
II Tighten blade screw securely by turning it clockwise
with the wrench.
NOTE; Never use a b)ade that is too thick to a!low the
"D" washer to engage with the fiat on the spindle.
OUTERBLADEWASHER
UPPEDSIDEOF OUTSIDEOFSPRING
PRINGWASHER WASHER
Fig, 3
tl
Loading ...
Loading ...
Loading ...