Loading ...
Loading ...
Loading ...
TROUBLESHOOTING CHART
PROBLEM CAUSE CORRECTION
Mowerbladeswill 1. Obstruction in clutch 1, Remove obstruction.
not rotate mechanism.
2, Worn/damaged mower 2. Replace mower drive belt,
drive belt.
3, Frozen idler pulley, 3. Replace idler pulley.
4. Frozen blade mandrel, 4. Replace blade mandrel.
1. Engine speed too slow,
Poor grass
discharge
Headlight(s) not
working
(if so equipped)
Battery will not
charge
2. Travelspeed too fast.
3. Wet grass.
4. Mower deck not level.
5. Low/uneven tire air
pressure.
6. Worn, bent or loose blade.
7. Buildup of grass, leaves
and trash under mower.
8. Mower drive belt worn.
9. Blades improperly installed.
10.Improper blades used.
11.Clogged mower deck vent
holes from buildup of grass,
leaves, and trash around
mandrels.
1. Switch is"OFF".
2. Bulb(s) or lamp(s) burned
out.
3. Faulty light switch.
4. Loose or damaged wiring.
5. Blown fuse.
1. Bad battery cell(s).
2, Poor cable connections.
1. Place throttle control in
"FAST" position.
2. Shift to slower speed.
3. Allow grass to dry before
mowing.
4. Level mower deck.
5. Check tires for proper air
pressure.
6. Replace/sharpen blade.
Tighten blade bolt.
7. Clean underside of mower
housing.
8. Replace mower drive belt.
9. Reinstall blades sharp edge
down.
10.Replace with blades listed
in this manual.
11.Clean around mandrels to
open vent holes.
1. Turn switch"ON".
2, Replace bulb(s) or lamp(s).
3. Check/replace light switch.
4, Check widng and connec-
tions.
5. Replace fuse.
1, RepTace battery.
2. Check/clean all connec-
tions.
3. Replace regulator.
3. Faulty regulator
(if so equipped).
4. Faultyalternator. 4. Replace alternator.
Engine"backfires" 1. Engine throttle control not 1. Move throttlecontrol to
whentuming set at "SLOW" position =SLOW" position and allow
engine "OFF" for 30 seconds before to idle for 30 seconds before
stopping engine, stopping engine.
3O
Loading ...
Loading ...
Loading ...