Loading ...
Loading ...
Loading ...
PositiveTerminal
Negative Terminal
Keps Hex
Nut _. Bolt
Cables
PositiveTerminal
Negative Terminal
REPLACING BATTERY
/LCAUTION: Do not short battery
terminals by allowing a wrench or any
other object to contact both terminals at
the same time. Before connecting battery,
remove metal bracelets, wristwatch
bands, rings, etc.
Positiveterminal must be connected first
to prevent sparking from accidental
grounding.
1. Lift seat pan to raised position and
open battery box door.
2. Disconnect BLACK battery cable first
then RED battery cable and carefully
remove batteryfrom tractor.
3. Install new battery with terminals in
same positionas old battery.
4. First connect RED battery cable to
positive (+) terminal with hex boltand
keps nut as shown. Tighten securely.
5. Connect BLACK grounding cable to
negative (-) terminal with remaining
hex bolt and keps nut. Tighten
securely.
6. Close battery box door.
Battery
Door
Negative (Black)
Positive (Red) Cable Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Pull bulb holderout of the hole in the
backside of the grill.
3. Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiringmay cause your
tractorto run poorly,stop running,or
prevent itfrom starting.
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp automotive-type
plug-infuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL
ASSEMBLY
1, Raise hood.
2. Unsnap headlight wire connector.
3. Stand infront of tractor. Grasp hoodat
sides, tilttoward engine and lift off of
tractor.
4. To replace, reverse above procedure.
HeadlightWire
Connector
25
Loading ...
Loading ...
Loading ...