Loading ...
Loading ...
Loading ...
18
Carefully lift o the outer door panel. The inside face of the
glass panels can now be cleaned – take care not to disturb or
wet the door insulation.
Note: If the door is triple glazed then the inner two panels are
xed together and should not be separated. After cleaning,
carefully ret the outer door panel and replace the side xing
screws.
DO NOT use harsh abrasive cleaners or sharp metal
scrapers to clean the oven door glass since they can
scratch the surface, which may result in shattering of
the glass.
Ovens
Cleaning is easier if carried out while the oven is still warm.
Before cleaning, cover the burner to prevent the burner holes
becoming blocked.
The inside of the oven and inner door panel can be cleaned
using an approved cleaner (Table 6.1).
Take care not to disturb the oven thermostat temperature
sensor at the top of the oven opening (Fig. 6.11).
The enamelled oven burner trim (Fig. 6.12) can be removed
for cleaning.
The oven burner trim hooks onto the front of the oven burner
bracket. When retting make sure that the trim is in the
middle of the front of the oven burner bracket (Fig. 6.13).
‘Cook & Clean’ Panels
The ovens have panels which have been coated with a special
enamel that partly cleans itself. This does not stop all marks
on the lining, but helps to reduce the amount of manual
cleaning needed.
The ‘Cook & Clean’ panels work better above 200 °C. If you do
most of your cooking below this temperature, occasionally
remove the panels and wipe with a lint free cloth and hot
soapy water. The panels should then be dried and replaced
and the oven heated at 200 °C for about one hour. This
will make sure that the ‘Cook & Clean’ panels are working
eectively.
Do not use steel wool, oven cleaning pads, or any other
materials that will scratch the surface.
Removing the Panels to Clean the
Enamel Interior
Some of the lining panels can be removed for cleaning.
If you wish to clean the enamel interior of the oven, you
will need to remove the shelves before removing the ‘Cook
& Clean’ panels . You do not have to remove the support
brackets to remove the panels. Lift each panel upward and
slide forward o the support brackets (Fig. 6.14).
Once the panels have been removed, the oven enamel
interior can be cleaned.
Ret in the reverse order.
Thermostat temperature sensor
ArtNo.323-0009 - Bray burner shield fitted
Oven burner trim
ArtNo.323-00011 - Bray burner front shield
Fig. 6.11
Fig. 6.12
Fig. 6.13
Fig. 6.14
Fig. 6.15
Loading ...
Loading ...
Loading ...